Difficulty

Difficult

Steps

12

Time Required

                          10 minutes            

Sections

2

  • Back Panel
  • 1 step
  • Screen
  • 11 steps

Flags

1

Needs More Images

A few more images would make this guide’s procedures crystal clear.

  • BackDigiLand DL718M

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

If you are considering replacing your screen because of unresponsiveness, refer to the DigiLand DL718M Troubleshooting page to find out what could be causing this problem and if it can be fixed without replacing the screen.

This process requires you to remove the back panel of the device and thus expose the motherboard. Be careful when working with an exposed motherboard as you could damage it, if it comes into contact with moisture. It is motion-sensitive, and small aspects can be easily jostled out of place.

Before you begin, make sure to power the tablet off completely and disconnect it from any external power source.

What you need

Step 1

              Back Panel               
  • Remove back panel by wedging the iFixit opening tool on all four sides of the device.

Remove back panel by wedging the iFixit opening tool on all four sides of the device.

1024

Step 2

              Screen               
  • Remove two silver Phillips #0 screws along the bottom of the internal panel.

Remove two silver Phillips #0 screws along the bottom of the internal panel.

Step 3

  • Remove the ribbon in the bottom left corner of the motherboard by lifting the black tab and sliding the ribbon out from the slot underneath the black tab.

Remove the ribbon in the bottom left corner of the motherboard by lifting the black tab and sliding the ribbon out from the slot underneath the black tab.

Step 4

  • Remove the small, circular microphone on the left side of the device by sliding it out of its slot using an opening tool.

Remove the small, circular microphone on the left side of the device by sliding it out of its slot using an opening tool.

Step 5

  • Remove the front-facing camera in the top left corner of the device by sliding it out of its slot using an opening tool.

Remove the front-facing camera in the top left corner of the device by sliding it out of its slot using an opening tool.

Step 6

  • Remove the three black Phillips #0 screws along the left side of the motherboard.

Remove the three black Phillips #0 screws along the left side of the motherboard.

Step 7

  • Detach the black tape and the wire from the right side of the screen.

Detach the black tape and the wire from the right side of the screen.

Step 8

  • Remove the rear-facing camera by prying it off of the back side of the screen using the an opening tool.

Remove the rear-facing camera by prying it off of the back side of the screen using the an opening tool.

Step 9

  • Lift the motherboard and remove it from the device using an opening tool.
  • If there is any tape on the device that prohibits you from doing so, remove the tape.

Lift the motherboard and remove it from the device using an opening tool.

If there is any tape on the device that prohibits you from doing so, remove the tape.

Step 10

  • Remove the ribbon above the battery by lifting the black tab and sliding the ribbon out from the slot underneath the black tab using an opening tool.

Remove the ribbon above the battery by lifting the black tab and sliding the ribbon out from the slot underneath the black tab using an opening tool.

Step 11

  • Pry the battery off of the back of the screen by wedging the iFixit opening tool underneath.

Pry the battery off of the back of the screen by wedging the iFixit opening tool underneath.

Step 12

  • Lift the screen from the plastic casing.

Lift the screen from the plastic casing.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 5 other contributors 

                    Alayna Knarian                     

Member since: 10/15/2019

734 Reputation

                                      6 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges                           

Team

                       Grand Valley State University, Team S4-G4, DeVasto Fall 2019                        

                                                  Member of Grand Valley State University, Team S4-G4, DeVasto Fall 2019 



                    GVSU-DEVASTO-F19S4G4                     


                                            4 Members                     


                                            6 Guides authored                     

jrtu2001 - Feb 9, 2020

Reply

What happen after? How remove the LCD screen? ……..INCOMPLETE