Difficulty

Moderate

Steps

6

Time Required

                          10 minutes

Sections

2

  • Rear Case
  • 3 steps
  • Front and Rear Cameras
  • 3 steps

Flags

0

  • BackDigiLand DL1010Q

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

  • Proficiently remove the front and back camerasLocate and understand how to detach a ZIF Connector

What you need

Step 1

              Rear Case
  • With a J00 Philips head screwdriver, unscrew the two 4mm black screws located at the bottom of the device.
  • Before disassembling your device, be sure it is powered off.

With a J00 Philips head screwdriver, unscrew the two 4mm black screws located at the bottom of the device.

Before disassembling your device, be sure it is powered off.

1024

Step 2

  • Using a plastic opening tool, begin softly prying open device by first inserting it in between the front and back panels.
  • Continue prying the edges while moving around the device’s perimeter until the back can be easily removed.

Using a plastic opening tool, begin softly prying open device by first inserting it in between the front and back panels.

Continue prying the edges while moving around the device’s perimeter until the back can be easily removed.

Step 3

  • Carefully lift back panel away from the body of the device.
  • Speaker wires are connected to both the front and back panel.

Carefully lift back panel away from the body of the device.

Speaker wires are connected to both the front and back panel.

Step 4

              Front and Rear Cameras
  • Begin by grabbing the tweezers and locating the ZIF ( zero Insertion Force) connector.

Begin by grabbing the tweezers and locating the ZIF ( zero Insertion Force) connector.

Step 5

  • Insert the tweezers into the black part of the ZIF connector and lift it in an upwards motion. By lifting the connection, you will see it will free the circuit strip.

Insert the tweezers into the black part of the ZIF connector and lift it in an upwards motion. By lifting the connection, you will see it will free the circuit strip.

Step 6

  • Take the tweezers and carefully grab the camera closest to the logic board and then pulling in an upwards motion will release both cameras from the device.
  • Set the cameras aside.

Take the tweezers and carefully grab the camera closest to the logic board and then pulling in an upwards motion will release both cameras from the device.

Set the cameras aside.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 1 other contributor 


                    Marissa Saidy

Member since: 09/28/2015

354 Reputation

                                      2 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Eastern Washington University, Team 1-5, Matresse Fall 2015                        

                                                  Member of Eastern Washington University, Team 1-5, Matresse Fall 2015 



                    EWU-MATRESSE-F15S1G5                     


                                            4 Members                     


                                            10 Guides authored