Difficulty
Moderate
Steps
6
Time Required
7 - 15 minutes
Sections
2
- Rear Case
- 3 steps
- Battery
- 3 steps
Flags
0
BackDigiLand DL1010Q
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Rear Case
- With a J00 Philips head screwdriver, unscrew the two 4mm black screws located at the bottom of the device.
- Before disassembling your device, be sure it is powered off.
With a J00 Philips head screwdriver, unscrew the two 4mm black screws located at the bottom of the device.
Before disassembling your device, be sure it is powered off.
1024
Step 2
- Using a plastic opening tool, begin softly prying open device by first inserting it in between the front and back panels.
- Continue prying the edges while moving around the device’s perimeter until the back can be easily removed.
Using a plastic opening tool, begin softly prying open device by first inserting it in between the front and back panels.
Continue prying the edges while moving around the device’s perimeter until the back can be easily removed.
Step 3
- Carefully lift back panel away from the body of the device.
- Speaker wires are connected to both the front and back panel.
Carefully lift back panel away from the body of the device.
Speaker wires are connected to both the front and back panel.
Step 4
Battery
- Desolder positive and negative, red and black, wires from the mother board that are connected to the battery.
- The soldering tool is hot, and will burn. For how to use a soldering tool follow the How to Solder Guide
Desolder positive and negative, red and black, wires from the mother board that are connected to the battery.
The soldering tool is hot, and will burn. For how to use a soldering tool follow the How to Solder Guide
Step 5
- Using a metal spudger tool, wedge between battery and metal screen.
- Follow the edge of the battery to loosen the glue.
Using a metal spudger tool, wedge between battery and metal screen.
Follow the edge of the battery to loosen the glue.
Step 6
- Once the glue is loosened, you should be able to pry off the battery from the screen.
- Using your hands, pull up on the battery to pull battery off.
- Pulling on the battery causes you to bend the battery. Bending the battery could cause it to break open. Battery fumes are toxic and unsafe.
- The battery will be completely disconnected and you can set the battery aside in a safe place.
Once the glue is loosened, you should be able to pry off the battery from the screen.
Using your hands, pull up on the battery to pull battery off.
Pulling on the battery causes you to bend the battery. Bending the battery could cause it to break open. Battery fumes are toxic and unsafe.
The battery will be completely disconnected and you can set the battery aside in a safe place.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Faith Lebo
Member since: 09/28/2015
192 Reputation
1 Guide authored
Badges:
9
+6 more badges
Team
Eastern Washington University, Team 1-5, Matresse Fall 2015
Member of Eastern Washington University, Team 1-5, Matresse Fall 2015
EWU-MATRESSE-F15S1G5
4 Members
10 Guides authored
javier perez - Feb 18, 2017
Reply
the replacemet has 3 wires .where go the 3 wire?
Theresa - May 26, 2018
Reply
were can i buy a new bettery
EIE™ - Mar 11, 2021
Reply
