Difficulty

Easy

Steps

15

Time Required

                          4 minutes

Sections

1

  • Speed variator
  • 15 steps

Flags

3

Grammar Police

Embrace your inner English teacher and help improve this guide’s grammar!

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackCorded Belt Sander Dexter - 900BS2.5

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Unplug
  • Before starting, remember to disconnect the outlet from the mains.

Before starting, remember to disconnect the outlet from the mains.

1024

Step 2

  • Remove the handle, by unscrewing the screw.

Remove the handle, by unscrewing the screw.

Step 3

  • Remove the strip by leverling.

Remove the strip by leverling.

Step 4

  • Unscrew the 4 screws.

Unscrew the 4 screws.

Step 5

  • Remove the belt, then unscrew the screws from the shell to access the engine.

Remove the belt, then unscrew the screws from the shell to access the engine.

Step 6

  • Remove the screws from the hull to have access inside and allow the coals to be blocked.

Remove the screws from the hull to have access inside and allow the coals to be blocked.

Step 7

  • Lift the speed variator, you can use a small screwdriver to get it out.

Lift the speed variator, you can use a small screwdriver to get it out.

Step 8

  • Turn the dimmer over to have good access to be able to unweld the wires.

Turn the dimmer over to have good access to be able to unweld the wires.

Step 9

  • Unweld the cables connected to the motor and suck the excess with a pump.

Unweld the cables connected to the motor and suck the excess with a pump.

Step 10

  • Unscrew the two screws from the switch to extract the second cable.
  • To extract the cables you can use a clamp.

Unscrew the two screws from the switch to extract the second cable.

To extract the cables you can use a clamp.

Step 11

  • Change the speed variator and then disconnect the cable from the switch.

Change the speed variator and then disconnect the cable from the switch.

Step 12

  • Reseating the motor cables to the dimmer.

Reseating the motor cables to the dimmer.

Step 13

  • Replace the dimmer in its housing.
  • Be careful to put the cables back on so that it is not pinched.

Replace the dimmer in its housing.

Be careful to put the cables back on so that it is not pinched.

Step 14

  • Screw the four screws.

Screw the four screws.

Step 15

  • Replace the tip, strip and handle.

Replace the tip, strip and handle.

Cancel: I did not complete this guide.

        HelloMacOS is helping us fix the world!      Want to contribute?      Start translating ›

Special thanks to these translators:

100%

HelloMacOS

Author

                                      with 1 other contributor 


                    Céline Chemineau

Member since: 01/29/2020

16,042 Reputation

                                      95 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       Leroy Merlin                        

                                                  Member of Leroy Merlin 



                    Community                     


                                            36 Members                     


                                            223 Guides authored