Difficulty
Easy
Steps
7
Time Required
5 minutes
Sections
1
- Switch
- 7 steps
Flags
2
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
Better Introduction
Improve this guide by completing or revising its introduction.
BackDexter 2100W corded angle grinder - 2100AG2-230.5
Full Screen
Options
History
Save to Favorites
Download PDF
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Unplug
- Before you begin, remember to disconnect the mains plug.
Before you begin, remember to disconnect the mains plug.
1024
Step 2
- To begin remove the side handle and the protective cover.
To begin remove the side handle and the protective cover.
Step 3
- Unscrew the screws of the hull to have access to the interior.
Unscrew the screws of the hull to have access to the interior.
Step 4
- Unscrew the wires belonging to the power cable from the switch.
- Then pull out the switch.
Unscrew the wires belonging to the power cable from the switch.
Then pull out the switch.
Step 5
- Replace the new switch.
Replace the new switch.
Step 6
- Reseat the power cable wires.
Reseat the power cable wires.
Step 7
- Make sure that no cable is pinched and that the cable sheath is well up.
- Tighten the screws to close the hull.
Make sure that no cable is pinched and that the cable sheath is well up.
Tighten the screws to close the hull.
Cancel: I did not complete this guide.
HelloMacOS is helping us fix the world! Want to contribute? Start translating ›
Special thanks to these translators:
100%
HelloMacOS
Author
with 1 other contributor
Céline Chemineau
Member since: 01/29/2020
16,042 Reputation
95 Guides authored
Badges:
11
+8 more badges
Team
Leroy Merlin
Member of Leroy Merlin
Community
36 Members
223 Guides authored
