Dexter Corded Circular Saw 1300Cis2 185 5 Height Adjustment Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 minutes

Sections

Height adjustment
10 steps

Flags

Grammar Police

Embrace your inner English teacher and help improve this guide’s grammar!

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

Better Introduction

Improve this guide by completing or revising its introduction.

BackCorded Circular Saw 1300W DEXTER- 1300CIS2-185.5
Full Screen
Options
History
Save to Favorites
Download PDF
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Unplug

Before you begin, remember to disconnect the mains plug.

Before you begin, remember to disconnect the mains plug.

1024

Step 2

Remove the dust extraction nozzle, blade and edge guide.
Refer to the instructions for the device to remove them.

Remove the dust extraction nozzle, blade and edge guide.

Refer to the instructions for the device to remove them.

Step 3

Open wide to free up space for a better work area.

Open wide to free up space for a better work area.

Step 4

Using a large pat screwdriver, remove the small pin.

Using a large pat screwdriver, remove the small pin.

Step 5

Then remove the black rod.

Then remove the black rod.

Step 6

And finally unscrew the nut.

And finally unscrew the nut.

Step 7

Here is the order of the parts to remove.

Here is the order of the parts to remove.

Step 8

Then we replace the height adjustment.

Then we replace the height adjustment.

Step 9

Finally put each piece back in order.
To tighten, simply replace the tray at the bottom and hand tighten the nut.
With the lever, take the nut and put it in the locked position without effort
It should be tight but not touching the board.

Finally put each piece back in order.

To tighten, simply replace the tray at the bottom and hand tighten the nut.

With the lever, take the nut and put it in the locked position without effort

It should be tight but not touching the board.

Step 10

Replace the blade, edge guide, and extraction bit on the saw.

Replace the blade, edge guide, and extraction bit on the saw.

to reassemble perform the steps in reverse order.

Cancel: I did not complete this guide.

        HelloMacOS is helping us fix the world!      Want to contribute?      Start translating ›

Special thanks to these translators:

100%

HelloMacOS

Author

                                      with 1 other contributor

                    Céline Chemineau

Member since: 01/29/2020

16,042 Reputation

                                      95 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       Leroy Merlin                        

                                                  Member of Leroy Merlin 



                    Community                     


                                            36 Members                     


                                            223 Guides authored

Grammar Police#

Member-Contributed Guide#

Better Introduction#

Introduction#

What you need#

Team#