Difficulty
Very easy
Steps
6
Time Required
1 minute
Sections
1
- carbon
- 6 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackCorded Circular Saw 1300W DEXTER- 1300CIS2-185.5
Full Screen
Options
History
Save to Favorites
Download PDF
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Unplug
- Before you begin, remember to disconnect the mains plug.
Before you begin, remember to disconnect the mains plug.
1024
Step 2
- Remove the dust extraction nozzle, blade and edge guide.
- Refer to the instructions for the device to remove them.
Remove the dust extraction nozzle, blade and edge guide.
Refer to the instructions for the device to remove them.
Step 3
- Unscrew the screw to access the brushes.
Unscrew the screw to access the brushes.
Step 4
- Take the carbons out of their housing.
Take the carbons out of their housing.
Step 5
- Replace the new carbon brushes in their housing.
- When putting the new carbon back, check that the legs of the carbons are well located in the rectangles.
Replace the new carbon brushes in their housing.
When putting the new carbon back, check that the legs of the carbons are well located in the rectangles.
Step 6
- Replace the blade, edge guide, and extraction bit on the saw.
Replace the blade, edge guide, and extraction bit on the saw.
you will have replace the carbon by the end of the guide
Cancel: I did not complete this guide.
HelloMacOS is helping us fix the world! Want to contribute? Start translating ›
Special thanks to these translators:
100%
HelloMacOS
Author
with 1 other contributor
Céline Chemineau
Member since: 01/29/2020
16,042 Reputation
95 Guides authored
Badges:
11
+8 more badges
Team
Leroy Merlin
Member of Leroy Merlin
Community
36 Members
223 Guides authored
