Difficulty
Easy
Steps
6
Time Required
4 minutes
Sections
1
- Power cable
- 6 steps
Flags
2
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
Better Introduction
Improve this guide by completing or revising its introduction.
BackCorded Reciprocating Saw Dexter 900W - 900RPS
Full Screen
Options
History
Save to Favorites
Download PDF
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Unplug
- Before you begin, remember to disconnect the mains plug.
Before you begin, remember to disconnect the mains plug.
1024
Step 2
- Unscrew the screws of the hull to open it.
Unscrew the screws of the hull to open it.
Step 3
- Unscrew the cable clamp.
Unscrew the cable clamp.
Step 4
- Remove the two screws from the switch.
- Then remove the cable.
Remove the two screws from the switch.
Then remove the cable.
Step 5
- Reconnect the new cable to the switch, then tighten the cable clamp.
Reconnect the new cable to the switch, then tighten the cable clamp.
Step 6
- Before closing, check that no cable is blocked and that each part is in its place.
- Then retighten the hull screws.
Before closing, check that no cable is blocked and that each part is in its place.
Then retighten the hull screws.
By the end of the guide you will have successfully replaced your power cable
Cancel: I did not complete this guide.
HelloMacOS is helping us fix the world! Want to contribute? Start translating ›
Special thanks to these translators:
100%
HelloMacOS
Author
with 1 other contributor
Céline Chemineau
Member since: 01/29/2020
16,042 Reputation
95 Guides authored
Badges:
11
+8 more badges
Team
Leroy Merlin
Member of Leroy Merlin
Community
36 Members
223 Guides authored