Difficulty

Easy

Steps

13

Time Required

                          4 minutes

Sections

1

  • Rotor
  • 13 steps

Flags

3

Grammar Police

Embrace your inner English teacher and help improve this guide’s grammar!

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackDEXTER 900W Corded drill Hammer- 900ID2.5

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Unplug
  • Before you begin, remember to disconnect the mains plug.

Before you begin, remember to disconnect the mains plug.

1024

Step 2

  • Remove the handle from the machine.

Remove the handle from the machine.

Step 3

  • Using a screwdriver or screwdriver, unscrew and open the device.

Using a screwdriver or screwdriver, unscrew and open the device.

Step 4

  • Unscrew the four screws.

Unscrew the four screws.

Step 5

  • Using a screwdriver, lift the spring of the two brushes.

Using a screwdriver, lift the spring of the two brushes.

Step 6

  • Lift the rotor and the stator and disassemble them.

Lift the rotor and the stator and disassemble them.

Step 7

  • Disassemble the two parts.

Disassemble the two parts.

Step 8

  • Before reassembling the new part, be sure to re-grease.

Before reassembling the new part, be sure to re-grease.

Step 9

  • Reassemble the two parts and replace them in their place.

Reassemble the two parts and replace them in their place.

Step 10

  • Reposition the brush springs.

Reposition the brush springs.

Step 11

  • Then retighten the four screws.

Then retighten the four screws.

Step 12

  • Before closing, check that no cable is blocked and that each part is in its place.
  • Tighten the screws to close the device.

Before closing, check that no cable is blocked and that each part is in its place.

Tighten the screws to close the device.

Step 13

  • Finally replace the handle.

Finally replace the handle.

By the end of the guide you will have successfully replaced the rotor

To reassemble perform the steps in reverse

Cancel: I did not complete this guide.

        HelloMacOS is helping us fix the world!      Want to contribute?      Start translating ›

Special thanks to these translators:

100%

HelloMacOS

Author

                                      with 1 other contributor 


                    Céline Chemineau

Member since: 01/29/2020

16,042 Reputation

                                      95 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       Leroy Merlin                        

                                                  Member of Leroy Merlin 



                    Community                     


                                            36 Members                     


                                            223 Guides authored