Difficulty
Easy
Steps
7
Time Required
2 minutes
Sections
1
- Power cable
- 7 steps
Flags
2
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
Better Introduction
Improve this guide by completing or revising its introduction.
BackDEXTER 900W Corded drill Hammer- 900ID2.5
Full Screen
Options
History
Save to Favorites
Download PDF
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Unplug
- Before you begin, remember to disconnect the mains plug.
Before you begin, remember to disconnect the mains plug.
1024
Step 2
- Remove the handle from the machine.
Remove the handle from the machine.
Step 3
- Using a screwdriver or screwdriver, unscrew and open the device.
Using a screwdriver or screwdriver, unscrew and open the device.
Step 4
- Lift the switch and unscrew the screws to release the cable.
Lift the switch and unscrew the screws to release the cable.
Step 5
- Replace the new power cable and connect the cables to the switch.
- Replace the switch in its housing.
Replace the new power cable and connect the cables to the switch.
Replace the switch in its housing.
Step 6
- Before closing, check that no cable is blocked and that each part is in its place.
- Tighten the screws to close the device.
Before closing, check that no cable is blocked and that each part is in its place.
Tighten the screws to close the device.
Step 7
- Finally replace the handle.
Finally replace the handle.
To reassemble complete steps in reverse or complete guide
Cancel: I did not complete this guide.
HelloMacOS is helping us fix the world! Want to contribute? Start translating ›
Special thanks to these translators:
100%
HelloMacOS
Author
with 1 other contributor
Céline Chemineau
Member since: 01/29/2020
16,042 Reputation
95 Guides authored
Badges:
11
+8 more badges
Team
Leroy Merlin
Member of Leroy Merlin
Community
36 Members
223 Guides authored