Difficulty

Easy

Steps

15

Time Required

                          10 minutes

Sections

1

  • output shaft
  • 15 steps

Flags

2

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackDEXTER 900W Corded drill Hammer- 900ID2.5

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Unplug
  • Before you begin, remember to disconnect the mains plug.

Before you begin, remember to disconnect the mains plug.

1024

Step 2

  • Remove the handle from the machine.

Remove the handle from the machine.

Step 3

  • Open the chuck to the maximum to gain access to the inner screw.

Open the chuck to the maximum to gain access to the inner screw.

Step 4

  • Lock the chuck using a 15 spanner (thickness 3), then unscrew to the right with a pz3 screwdriver.

Lock the chuck using a 15 spanner (thickness 3), then unscrew to the right with a pz3 screwdriver.

Step 5

  • Using a pair of pliers, unscrew the chuck.

Using a pair of pliers, unscrew the chuck.

Step 6

  • Using a screwdriver or screwdriver, unscrew and open the device.

Using a screwdriver or screwdriver, unscrew and open the device.

Step 7

  • Unscrew the four screws.

Unscrew the four screws.

Step 8

  • Using a screwdriver, lift the spring of the two brushes.

Using a screwdriver, lift the spring of the two brushes.

Step 9

  • Remove the output shaft.
  • Before replacing the new part, be sure to re-grease.

Remove the output shaft.

Before replacing the new part, be sure to re-grease.

Step 10

  • Reposition the brush springs.

Reposition the brush springs.

Step 11

  • Then retighten the four screws.

Then retighten the four screws.

Step 12

  • Before closing, check that no cable is blocked and that each part is in its place.
  • Tighten the screws to close the device.

Before closing, check that no cable is blocked and that each part is in its place.

Tighten the screws to close the device.

Step 13

  • Replace the chuck.

Replace the chuck.

Step 14

  • Screw the chuck back on by hand.
  • Then using a screwdriver replace the screw, and screw to the left.

Screw the chuck back on by hand.

Then using a screwdriver replace the screw, and screw to the left.

Step 15

  • Finally replace the handle.

Finally replace the handle.

in order to reassemble preform the steps in reverse order.

Cancel: I did not complete this guide.

        HelloMacOS is helping us fix the world!      Want to contribute?      Start translating ›

Special thanks to these translators:

100%

HelloMacOS

Author

                                      with 1 other contributor 


                    Céline Chemineau

Member since: 01/29/2020

16,042 Reputation

                                      95 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       Leroy Merlin                        

                                                  Member of Leroy Merlin 



                    Community                     


                                            36 Members                     


                                            223 Guides authored