Difficulty

Easy

Steps

10

Time Required

                          5 minutes

Sections

1

  • Switch
  • 10 steps

Flags

3

Grammar Police

Embrace your inner English teacher and help improve this guide’s grammar!

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackCorded jigsaw Dexter 750W - 750JS3-100.5

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Unplug
  • Before you begin, remember to disconnect the mains plug.

Before you begin, remember to disconnect the mains plug.

1024

Step 2

  • Remove the vacuum adapter from the back of the device.

Remove the vacuum adapter from the back of the device.

Step 3

  • Using a screwdriver or screwdriver, unscrew and open the device.
  • Unlock the tray by lifting the lever.

Using a screwdriver or screwdriver, unscrew and open the device.

Unlock the tray by lifting the lever.

Step 4

  • Remove the black screw, in order to remove the knob.

Remove the black screw, in order to remove the knob.

Step 5

  • Using a screwdriver, pry to be able to recover the wheel.

Using a screwdriver, pry to be able to recover the wheel.

Step 6

  • Turn over the switch, to be able to access the screw.

Turn over the switch, to be able to access the screw.

Step 7

  • Remove the four screws to be able to unlock the system and remove the wires.

Remove the four screws to be able to unlock the system and remove the wires.

Step 8

  • Replace the new switch and reseat the wires. Be careful to put each wire back in its place.
  • Following the picture, the red wire is at the top left, the blue wire at the top right, the blue and black wire at the bottom left, and the brown wire at the bottom right.
  • The cables must be placed below so as not to interfere with the closure and must not protrude.

Replace the new switch and reseat the wires. Be careful to put each wire back in its place.

Following the picture, the red wire is at the top left, the blue wire at the top right, the blue and black wire at the bottom left, and the brown wire at the bottom right.

The cables must be placed below so as not to interfere with the closure and must not protrude.

Step 9

  • Put the wheel back in its housing and screw it back on.

Put the wheel back in its housing and screw it back on.

Step 10

  • Close and screw the device.

Close and screw the device.

follow guide through or in reverse to reassemble

Cancel: I did not complete this guide.

        HelloMacOS is helping us fix the world!      Want to contribute?      Start translating ›

Special thanks to these translators:

100%

HelloMacOS

Author

                                      with 1 other contributor 


                    Céline Chemineau

Member since: 01/29/2020

16,042 Reputation

                                      95 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       Leroy Merlin                        

                                                  Member of Leroy Merlin 



                    Community                     


                                            36 Members                     


                                            223 Guides authored