Difficulty
Easy
Steps
6
Time Required
2 minutes
Sections
1
- blade holder
- 6 steps
Flags
2
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
Better Introduction
Improve this guide by completing or revising its introduction.
BackDexter 500W Corded Jigsaw Repair - 500JS2-65.5
Full Screen
Options
History
Save to Favorites
Download PDF
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Unplug
- Before you begin, remember to disconnect the mains plug.
Before you begin, remember to disconnect the mains plug.
1024
Step 2
- Start by unlocking the tray.
- Then unscrew to open the machine.
Start by unlocking the tray.
Then unscrew to open the machine.
Step 3
- Remove the blade holder, then remove the slider located at the end of the holder.
- Remember to keep the slider at the end of the support.
Remove the blade holder, then remove the slider located at the end of the holder.
Remember to keep the slider at the end of the support.
Step 4
- Before replacing the new blade holder, re-grease, then replace it.
Before replacing the new blade holder, re-grease, then replace it.
Step 5
- Check that each piece is in its place before closing.
Check that each piece is in its place before closing.
Step 6
- Replace the shell and then screw it back on.
- Retighten the chainring nuts to finish.
Replace the shell and then screw it back on.
Retighten the chainring nuts to finish.
Follow the guide through to reassemble or in reverse
Cancel: I did not complete this guide.
HelloMacOS is helping us fix the world! Want to contribute? Start translating ›
Special thanks to these translators:
100%
HelloMacOS
Author
with 1 other contributor
Céline Chemineau
Member since: 01/29/2020
16,042 Reputation
95 Guides authored
Badges:
11
+8 more badges
Team
Leroy Merlin
Member of Leroy Merlin
Community
36 Members
223 Guides authored
