Difficulty
Easy
Steps
9
Time Required
5 minutes
Sections
1
- Power cable
- 9 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackPonceuse Vibrante Filaire Dexter 330W - 330SHS2.5
Full Screen
Options
History
Save to Favorites
Download PDF
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Unplug
- Before starting, remember to disconnect the outlet from the mains.
Before starting, remember to disconnect the outlet from the mains.
1024
Step 2
- Remove the dust case and the seal on the back of the device.
Remove the dust case and the seal on the back of the device.
Step 3
- Unscrew the six screws from the pad.
- Lock the motor with a screwdriver to be able to unscrew the centre screw, you will not be able to get there without blocking the gear.
Unscrew the six screws from the pad.
Lock the motor with a screwdriver to be able to unscrew the centre screw, you will not be able to get there without blocking the gear.
Step 4
- Using a screwdriver or screwdriver, unscrew and open the device.
Using a screwdriver or screwdriver, unscrew and open the device.
Step 5
- Unscrew the two screws from the domino to pull out the brown and blue cables.
Unscrew the two screws from the domino to pull out the brown and blue cables.
Step 6
- Reconnect the new cable to the domino.
- Then replace the cable, the sheath must arrive between the two pads and the sleeve must be positioned in its housing.
Reconnect the new cable to the domino.
Then replace the cable, the sheath must arrive between the two pads and the sleeve must be positioned in its housing.
Step 7
- Replace the shell, then screw it back on.
- Remember to put the joint back in its place.
Replace the shell, then screw it back on.
Remember to put the joint back in its place.
Step 8
- Reposition the part, then lock the engine with a screwdriver to screw.
- Put the tray back on and screw the screws.
Reposition the part, then lock the engine with a screwdriver to screw.
Put the tray back on and screw the screws.
Step 9
- Finally, reposition the vacuum bag.
Finally, reposition the vacuum bag.
Cancel: I did not complete this guide.
HelloMacOS is helping us fix the world! Want to contribute? Start translating ›
Special thanks to these translators:
100%
HelloMacOS
Author
with 1 other contributor
Céline Chemineau
Member since: 01/29/2020
16,042 Reputation
95 Guides authored
Badges:
11
+8 more badges
Team
Leroy Merlin
Member of Leroy Merlin
Community
36 Members
223 Guides authored
