Dexter 300W Corded Delta Sander 300Ds2 5 Carbon Replacement Repair Guide

Difficulty

Moderate

Steps

13

Time Required

                          5 minutes            

Sections

1

• Carbon
• 13 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

• BackCorded Delta Sander Dexter 300W - 300DS2.5

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Unplug               

• Before you begin, remember to disconnect the mains plug.

Before you begin, remember to disconnect the mains plug.

1024

Step 2

• Remove the three screws from the pad.

Remove the three screws from the pad.

Step 3

• Be careful to keep the three small marbles.

Be careful to keep the three small marbles.

Step 4

• Unscrew the screws to open the shell.

Unscrew the screws to open the shell.

Step 5

• Remove the orange cap.

Remove the orange cap.

Step 6

• Using a screwdriver lift the brushes.

Using a screwdriver lift the brushes.

Step 7

• Remove the carbon from its housing then take it out.
• Using pliers, fold down the small tab.

Remove the carbon from its housing then take it out.

Using pliers, fold down the small tab.

Step 8

• Replace the new carbon in its carbon holder.

Replace the new carbon in its carbon holder.

Step 9

• Reconnect the carbon, test if the carbon slides well inside.

Reconnect the carbon, test if the carbon slides well inside.

Step 10

• Replace the coals in their housing.

Replace the coals in their housing.

Step 11

• Before closing, check that no cable is blocked and that each part is in its place.
• Replace the screws on the hull.

Before closing, check that no cable is blocked and that each part is in its place.

Replace the screws on the hull.

Step 12

• Replace the retaining flange, be careful to have the three small balls.

Replace the retaining flange, be careful to have the three small balls.

Step 13

• Tighten the three screws of the retaining plate then that of the pad.

Tighten the three screws of the retaining plate then that of the pad.

To reassemble follow guide through or in reverse

Cancel: I did not complete this guide.

        HelloMacOS is helping us fix the world!      Want to contribute?      Start translating › 

Special thanks to these translators:

100%

HelloMacOS

Author

                                      with 1 other contributor 

                    Céline Chemineau                     

Member since: 01/29/2020

16,042 Reputation

                                      95 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges                           

Team

                       Leroy Merlin                        

                                                  Member of Leroy Merlin 



                    Community                     


                                            36 Members                     


                                            223 Guides authored