Difficulty
Moderate
Steps
5
Time Required
15 - 20 minutes
Sections
1
- Brush Spring
- 5 steps
Flags
0
BackDeWalt DWE4011
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Brush Spring
- Turn to the bottom of the device and remove the 5/8" (17mm) screw shown using a T15 Torx Screwdriver.
Turn to the bottom of the device and remove the 5/8" (17mm) screw shown using a T15 Torx Screwdriver.
1024
Step 2
- Remove outer casing by pulling the end handle away from the field case.
Remove outer casing by pulling the end handle away from the field case.
Step 3
- Locate the brush springs on either side of the device.
Locate the brush springs on either side of the device.
Step 4
- Using an iFixit opening tool, remove the female terminal connecting the carbon brush wire to the male terminal.
Using an iFixit opening tool, remove the female terminal connecting the carbon brush wire to the male terminal.
Step 5
- Remove the spring by sliding it out of the center post (use an iFixit opening tool if needed).
- When replacing the spring you need to tension it. Watch this video at 1:55 to see how.
Remove the spring by sliding it out of the center post (use an iFixit opening tool if needed).
When replacing the spring you need to tension it. Watch this video at 1:55 to see how.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Jesus Quinones
Member since: 04/03/2019
272 Reputation
1 Guide authored
Badges:
8
+5 more badges
Team
Oregon Institute of Technology, Team S2-G9, Lancaster Spring 2019
Member of Oregon Institute of Technology, Team S2-G9, Lancaster Spring 2019
OIT-LANCASTER-S19S2G9
4 Members
5 Guides authored
