Difficulty

Very easy

Steps

2

Time Required

                          5 minutes

Sections

1

  • Blade
  • 2 steps

Flags

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs More Images

A few more images would make this guide’s procedures crystal clear.

  • BackDeWalt DWE305

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Note: Our device did not come with a blade attached, so the following guide will walk you through the steps of replacing the blade without any images of the blade itself.

Step 1

              Blade
  • Make sure that the device is unplugged from the power source and move device to well lit area. By doing this step you will reduce the likelihood of injury caused by the blade.

Make sure that the device is unplugged from the power source and move device to well lit area. By doing this step you will reduce the likelihood of injury caused by the blade.

1024

Step 2

  • While holding the blade in one hand use the other hand to lift the yellow latch located on the shoe of the device. Once the lever is lifted, slide the blade out of the device.

While holding the blade in one hand use the other hand to lift the yellow latch located on the shoe of the device. Once the lever is lifted, slide the blade out of the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Morgan Dudley

Member since: 09/04/2019

181 Reputation

                                      2 Guides authored                  



                       Badges:
                       2

Team

                       Embry-Riddle Aeronautical University, Team S23-G4, McClure Fall 2019                        

                                                  Member of Embry-Riddle Aeronautical University, Team S23-G4, McClure Fall 2019 



                    ERAU-MCCLURE-F19S23G4                     


                                            4 Members                     


                                            5 Guides authored