Difficulty

Moderate

Steps

7

Time Required

Suggest a time??

Sections

1

  • Power Cord
  • 7 steps

Flags

Slice and Dice

The steps in this guide should be split up and made into a series of prerequisite guides.

  • BackDeWalt DWD112

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Power Cord
  • Remove seven TR20 Torx Security screws from the side of the drill.

Remove seven TR20 Torx Security screws from the side of the drill.

1024

Step 2

  • Remove the top cover to reveal the inside of the drill.
  • Set the top cover of the drill aside.

Remove the top cover to reveal the inside of the drill.

Set the top cover of the drill aside.

Step 3

  • The power cord and the trigger act as a single part and must be replaced together.
  • Using one hand grab the trigger box and with the other grab the end of the wire connecting to the trigger box and disconnect the wire.

The power cord and the trigger act as a single part and must be replaced together.

Using one hand grab the trigger box and with the other grab the end of the wire connecting to the trigger box and disconnect the wire.

Step 4

  • Disconnect the second connected wire from the top of the trigger box.

Disconnect the second connected wire from the top of the trigger box.

Step 5

  • Lift the trigger box up to reveal the bottom side.
  • Disconnect the first connected wire from the bottom of the trigger box.

Lift the trigger box up to reveal the bottom side.

Disconnect the first connected wire from the bottom of the trigger box.

Step 6

  • Disconnect the last wire from the trigger box using the same method from the previous step.

Disconnect the last wire from the trigger box using the same method from the previous step.

Step 7

  • After all four wires are disconnected, the trigger and power cord are separated from the drill.
  • The power cord and trigger can be set aside if further disassembly is required.

After all four wires are disconnected, the trigger and power cord are separated from the drill.

The power cord and trigger can be set aside if further disassembly is required.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Samantha McSweeney

Member since: 03/07/2016

407 Reputation

                                      4 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       UMass Dartmouth, Team 2-3, Isaacson Spring 2016                        

                                                  Member of UMass Dartmouth, Team 2-3, Isaacson Spring 2016 



                    UMASSD-ISAACSON-S16S2G3                     


                                            3 Members                     


                                            6 Guides authored