Difficulty
Moderate
Steps
6
Time Required
5 minutes
Sections
2
- Clam Shell
- 3 steps
- Switch VSR
- 3 steps
Flags
0
BackDeWalt DW938
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Clam Shell
- Use a torque bit screw driver to remove the T10 18.3 mm screw on the handle.
- Use a torque bit screw driver to remove 6 T10 21.5 mm screws on the handle.
- Insure power source is removed from tool.
- Insure blade is removed from tool.
Use a torque bit screw driver to remove the T10 18.3 mm screw on the handle.
Use a torque bit screw driver to remove 6 T10 21.5 mm screws on the handle.
Insure power source is removed from tool.
Insure blade is removed from tool.
1024
Step 2
- Carefully cut the safety sticker with a blade along the seam.
Carefully cut the safety sticker with a blade along the seam.
Step 3
- Remove the Clam Shell from the handle unit.
Remove the Clam Shell from the handle unit.
Step 4
Switch VSR
- Lift the mechanical device off the pins of the clam shell.
Lift the mechanical device off the pins of the clam shell.
Step 5
- Remove the red and black trigger wires from the brush leads with the pliers.
Remove the red and black trigger wires from the brush leads with the pliers.
Step 6
- Remove the VSR trigger and the lock button.
Remove the VSR trigger and the lock button.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Christopher Chin
Member since: 03/08/2017
316 Reputation
3 Guides authored
Badges:
5
+2 more badges
Team
IUPUI, Team S4-G4, Baechle Spring 2017
Member of IUPUI, Team S4-G4, Baechle Spring 2017
IUPUI-BAECHLE-S17S4G4
4 Members
3 Guides authored
