Difficulty
Easy
Steps
5
Time Required
3 minutes
Sections
1
- Saw Blade
- 5 steps
Flags
0
BackDeWalt DW936
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Step 1
Saw Blade
- Take out the Allen Key that is located on the front of the saw below the smooth control handle on the top of the saw.
Take out the Allen Key that is located on the front of the saw below the smooth control handle on the top of the saw.
1024
Step 2
- Use the Allen Key to replace to loosen the bolt where the center of the saw is/would be.
Use the Allen Key to replace to loosen the bolt where the center of the saw is/would be.
Step 3
- Remove the circular nut that is used to hold the saw blade in place. It slide right off.
Remove the circular nut that is used to hold the saw blade in place. It slide right off.
Step 4
- Lift up the plastic cover on the bottom to expose the bottom slot on the saw.
Lift up the plastic cover on the bottom to expose the bottom slot on the saw.
Step 5
- Place blade on the peg in the middle of the saw. The peg has two flat sides as does the saw hole to prevent slipping when spinning.
Place blade on the peg in the middle of the saw. The peg has two flat sides as does the saw hole to prevent slipping when spinning.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
Scott Weinhardt
Member since: 01/25/2017
564 Reputation
5 Guides authored
Badges:
9
+6 more badges
Team
Cal Poly, Team 8-2, Banghart Winter 2017
Member of Cal Poly, Team 8-2, Banghart Winter 2017
CPSU-BANGHART-W17S8G2
3 Members
5 Guides authored
