Difficulty
Very easy
Steps
5
Time Required
5 - 10 minutes
Sections
2
- Disassembly
- 3 steps
- Trigger
- 2 steps
Flags
3
Bullets!
Better coordination with markups and the color/type of bullets will help make this guide more clear!
Missed a Step
Oops! This guide is currently missing some important steps.
Better Introduction
Improve this guide by completing or revising its introduction.
BackDeWalt DW920
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Disassembly
- Using an H-5.0 bit driver remove the four T-10 Torx screws.
Using an H-5.0 bit driver remove the four T-10 Torx screws.
1024
Step 2
- Use 2 H-5.0 bit drivers to take out the main bolt and head.
- There will be blue locktite on the tread.
Use 2 H-5.0 bit drivers to take out the main bolt and head.
There will be blue locktite on the tread.
Step 3
- Carefully remove the two halves of the handle.
Carefully remove the two halves of the handle.
Step 4
Trigger
- Gently lift the broken trigger assembly out of the slot.
Gently lift the broken trigger assembly out of the slot.
Step 5
- Carefully detach the solder points where the trigger assembly is attached to the motor assembly.
Carefully detach the solder points where the trigger assembly is attached to the motor assembly.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 5 other contributors
Stephen Rada
Member since: 03/11/2016
433 Reputation
4 Guides authored
Badges:
9
+6 more badges
Team
UMass Dartmouth, Team 8-2, Botvin Spring 2016
Member of UMass Dartmouth, Team 8-2, Botvin Spring 2016
UMASSD-BOTVIN-S16S8G2
2 Members
6 Guides authored
