Difficulty
Easy
Steps
6
Time Required
5 - 15 minutes
Sections
2
- Disassembly
- 3 steps
- Rotational Switch
- 3 steps
Flags
0
BackDeWalt DW920
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Disassembly
- Using an H-5.0 bit driver remove the four T-10 Torx screws.
Using an H-5.0 bit driver remove the four T-10 Torx screws.
1024
Step 2
- Use 2 H-5.0 bit drivers to take out the main bolt and head.
- There will be blue locktite on the tread.
Use 2 H-5.0 bit drivers to take out the main bolt and head.
There will be blue locktite on the tread.
Step 3
- Carefully remove the two halves of the handle.
Carefully remove the two halves of the handle.
Step 4
Rotational Switch
- Locate the rotational switch
Locate the rotational switch
Step 5
- Carefully release the connection between the rotational switch and the motor assembly. This should be done carefully to ensure that the switch connection switch on the assembly is not damaged.
Carefully release the connection between the rotational switch and the motor assembly. This should be done carefully to ensure that the switch connection switch on the assembly is not damaged.
Step 6
- Once the switch is freed from the assembly, firmly grip it between two fingers and lift it straight out of the drill frame.
Once the switch is freed from the assembly, firmly grip it between two fingers and lift it straight out of the drill frame.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 6 other contributors
Cameron MacKinnon
Member since: 04/06/2016
241 Reputation
2 Guides authored
Badges:
9
+6 more badges
Team
UMass Dartmouth, Team 8-2, Botvin Spring 2016
Member of UMass Dartmouth, Team 8-2, Botvin Spring 2016
UMASSD-BOTVIN-S16S8G2
2 Members
6 Guides authored
DankMemerino - Apr 22, 2016
Reply
Everything looks good on this guide, good job!
