Difficulty
Moderate
Steps
5
Time Required
15 minutes
Sections
2
- Disassembly
- 3 steps
- Lock Switch
- 2 steps
Flags
1
Better Introduction
Improve this guide by completing or revising its introduction.
BackDeWalt DW920
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Disassembly
- Using an H-5.0 bit driver remove the four T-10 Torx screws.
Using an H-5.0 bit driver remove the four T-10 Torx screws.
1024
Step 2
- Use 2 H-5.0 bit drivers to take out the main bolt and head.
- There will be blue locktite on the tread.
Use 2 H-5.0 bit drivers to take out the main bolt and head.
There will be blue locktite on the tread.
Step 3
- Carefully remove the two halves of the handle.
Carefully remove the two halves of the handle.
Step 4
Lock Switch
- Locate the switch on the top of the drill right before the bending joint.
Locate the switch on the top of the drill right before the bending joint.
Step 5
- Firmly grasp the switch with two fingers and lift it straight up. The spring should remain attached to the switch during this process.
- It should lift right out. If it is caught on anything do not force it out.
Firmly grasp the switch with two fingers and lift it straight up. The spring should remain attached to the switch during this process.
It should lift right out. If it is caught on anything do not force it out.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Stephen Rada
Member since: 03/11/2016
433 Reputation
4 Guides authored
Badges:
9
+6 more badges
Team
UMass Dartmouth, Team 8-2, Botvin Spring 2016
Member of UMass Dartmouth, Team 8-2, Botvin Spring 2016
UMASSD-BOTVIN-S16S8G2
2 Members
6 Guides authored
DankMemerino - Apr 22, 2016
Reply
This guide was descriptive and easy to follow. Good job!
