Difficulty
Easy
Steps
3
Time Required
5 minutes
Sections
1
- Power Switch
- 3 steps
Flags
0
BackDeWalt DW660
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Power Switch
- Remove the four 19mm T20 Torx screws at the rear of the device.
Remove the four 19mm T20 Torx screws at the rear of the device.
1024
Step 2
- Remove the cover to expose the inside of the tool.
Remove the cover to expose the inside of the tool.
Step 3
- Pick up the switch from the device with the wires still attached.
- Remove the actuator from the switch.
- Pull the two wires from the switch.
- Make sure to remember where each pin went on the switch after replacement.
Pick up the switch from the device with the wires still attached.
Remove the actuator from the switch.
Pull the two wires from the switch.
Make sure to remember where each pin went on the switch after replacement.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Joseph Pacitto
Member since: 03/23/2016
239 Reputation
2 Guides authored
Badges:
8
+5 more badges
Team
UMass Dartmouth, Team 2-7, Isaacson Spring 2016
Member of UMass Dartmouth, Team 2-7, Isaacson Spring 2016
UMASSD-ISAACSON-S16S2G7
3 Members
5 Guides authored
