Difficulty
Easy
Steps
4
Time Required
10 minutes
Sections
1
- Power Cord
- 4 steps
Flags
0
BackDeWalt DW660
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Power Cord
- Using a T20 Torx Screwdriver, unscrew the four 19mm screws from the back casing.
- After unscrewing, remove the back casing from the device.
Using a T20 Torx Screwdriver, unscrew the four 19mm screws from the back casing.
After unscrewing, remove the back casing from the device.
1024
Step 2
- Disconnect the wires from the switch terminals.
Disconnect the wires from the switch terminals.
Step 3
- Remove the ground wire from the motor by pulling it gently.
Remove the ground wire from the motor by pulling it gently.
Step 4
- Using the T20 Torx screwdriver, unscrew two screws from the bracket that holds the power cord in the casting.
Using the T20 Torx screwdriver, unscrew two screws from the bracket that holds the power cord in the casting.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
AL25
Member since: 03/09/2016
229 Reputation
2 Guides authored
Badges:
11
+8 more badges
Team
UMass Dartmouth, Team 2-7, Isaacson Spring 2016
Member of UMass Dartmouth, Team 2-7, Isaacson Spring 2016
UMASSD-ISAACSON-S16S2G7
3 Members
5 Guides authored
