Difficulty
Moderate
Steps
6
Time Required
15 minutes
Sections
3
- Battery
- 2 steps
- Drill Assembly
- 2 steps
- Forward/Reverse switch
- 2 steps
Flags
0
BackDeWalt DC970
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Compress the buttons on either side of the battery and lift the drill away from battery.
Compress the buttons on either side of the battery and lift the drill away from battery.
1024
Step 2
- Remove battery from drill.
Remove battery from drill.
Step 3
Drill Assembly
- Remove the eight 16 mm, Torx Security #15 screws.
Remove the eight 16 mm, Torx Security #15 screws.
Step 4
- Lay the drill on its side and gently lift the top half off it.
Lay the drill on its side and gently lift the top half off it.
Step 5
Forward/Reverse switch
- Remove the drill mechanism from the shell.
Remove the drill mechanism from the shell.
Step 6
- Disconnect the forward/reverse switch from the trigger by pulling the mechanism out and leaving the switch in the frame.
- To replace just pull the switch out and put the new one in the opening.
Disconnect the forward/reverse switch from the trigger by pulling the mechanism out and leaving the switch in the frame.
To replace just pull the switch out and put the new one in the opening.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
jake
Member since: 03/10/2016
303 Reputation
2 Guides authored
Badges:
9
+6 more badges
Team
UMass Dartmouth, Team 4-2, Catania Spring 2016
Member of UMass Dartmouth, Team 4-2, Catania Spring 2016
UMASSD-CATANIA-S16S4G2
3 Members
13 Guides authored
