Difficulty

Easy

Steps

6

Time Required

                          15 - 20 minutes

Sections

2

  • Disassembling DeWalt D28110 Back Panel Disassembly
  • 4 steps
  • Power Cord
  • 2 steps

Flags

0

  • BackDeWalt D28110

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Disassembling DeWalt D28110 Back Panel Disassembly
  • Using the T-15 screwdriver, remove the four 22-mm torx screws holding the back panel in place.
  • Unplug the grinder before any disassembly.

Using the T-15 screwdriver, remove the four 22-mm torx screws holding the back panel in place.

Unplug the grinder before any disassembly.

1024

Step 2

  • Use the edge of the spudger to loosen and remove the back panel.

Use the edge of the spudger to loosen and remove the back panel.

Step 3

  • Remove the single 20-mm torx screw holding the rear panel in place.

Remove the single 20-mm torx screw holding the rear panel in place.

Step 4

  • Pull back the rear side of the back panel.

Pull back the rear side of the back panel.

Step 5

              Power Cord
  • Locate the red switch box.
  • Using the J-10 screwdriver, unscrew the screws and detach the wires.
  • Be sure to remember under which screw the “ground” wire (black) goes.

Locate the red switch box.

Using the J-10 screwdriver, unscrew the screws and detach the wires.

Be sure to remember under which screw the “ground” wire (black) goes.

Step 6

  • Unthread the two wires from the power cord clamp.

Unthread the two wires from the power cord clamp.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Andrew

Member since: 01/22/2015

255 Reputation

                                      1 Guide authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Cal Poly, Team 18-6, Maness Winter 2015                        

                                                  Member of Cal Poly, Team 18-6, Maness Winter 2015 



                    CPSU-MANESS-W15S18G6                     


                                            5 Members                     


                                            7 Guides authored