Difficulty
Easy
Steps
6
Time Required
15 - 20 minutes
Sections
2
- Disassembling DeWalt D28110 Back Panel Disassembly
- 4 steps
- Brush Arm
- 2 steps
Flags
0
BackDeWalt D28110
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Disassembling DeWalt D28110 Back Panel Disassembly
- Using the T-15 screwdriver, remove the four 22-mm torx screws holding the back panel in place.
- Unplug the grinder before any disassembly.
Using the T-15 screwdriver, remove the four 22-mm torx screws holding the back panel in place.
Unplug the grinder before any disassembly.
1024
Step 2
- Use the edge of the spudger to loosen and remove the back panel.
Use the edge of the spudger to loosen and remove the back panel.
Step 3
- Remove the single 20-mm torx screw holding the rear panel in place.
Remove the single 20-mm torx screw holding the rear panel in place.
Step 4
- Pull back the rear side of the back panel.
Pull back the rear side of the back panel.
Step 5
Brush Arm
- Using the T-6 screwdriver, unscrew torx screw holding the arm in place.
Using the T-6 screwdriver, unscrew torx screw holding the arm in place.
Step 6
- Gently remove the arm from the assembly.
Gently remove the arm from the assembly.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Kean Wee
Member since: 01/22/2015
468 Reputation
4 Guides authored
Badges:
11
+8 more badges
Team
Cal Poly, Team 18-6, Maness Winter 2015
Member of Cal Poly, Team 18-6, Maness Winter 2015
CPSU-MANESS-W15S18G6
5 Members
7 Guides authored
