Difficulty
Moderate
Steps
9
Time Required
20 minutes
Sections
3
- Battery Cover
- 1 step
- Battery
- 1 step
- Motherboard
- 7 steps
Flags
2
Missed a Step
Oops! This guide is currently missing some important steps.
Better Introduction
Improve this guide by completing or revising its introduction.
BackDelphi XM2GO SA-10113
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery Cover
- Locate the large button on the top of the device.
- Push down on the button and slide the cover away from the button.
- The battery removal tab may pop up.
Locate the large button on the top of the device.
Push down on the button and slide the cover away from the button.
The battery removal tab may pop up.
1024
Step 2
Battery
- Grab the red pull tab and pull down to unlock the latch.
- Pull the battery out.
Grab the red pull tab and pull down to unlock the latch.
Pull the battery out.
Step 3
Motherboard
- Remove the four screws from the bottom of the device using a T6 Torx screwdriver.
Remove the four screws from the bottom of the device using a T6 Torx screwdriver.
Step 4
- Remove the button cover on the back of the device by prying it up with a spudger or your thumb nail.
Remove the button cover on the back of the device by prying it up with a spudger or your thumb nail.
Step 5
- Remove the two screws under the button using the T6 Torx screwdriver.
Remove the two screws under the button using the T6 Torx screwdriver.
Step 6
- Remove the back cover.
Remove the back cover.
Step 7
- Remove the power button by pulling it to the left.
Remove the power button by pulling it to the left.
Step 8
- Remove the plastic antenna extension connector on the right side of the device.
Remove the plastic antenna extension connector on the right side of the device.
Step 9
- Pull up on the motherboard to remove it from the device.
- The LCD screen and keypad are only connected to the motherboard with ribbon cables. They will hang down as the motherboard is removed.
Pull up on the motherboard to remove it from the device.
The LCD screen and keypad are only connected to the motherboard with ribbon cables. They will hang down as the motherboard is removed.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 6 other contributors
Scott Byer
Member since: 03/09/2012
61 Reputation
5 Guides authored
Badges:
10
+7 more badges
Team
Clemson, Team 1-2, Benson Spring 2012
Member of Clemson, Team 1-2, Benson Spring 2012
CLEM-BENSON-S12S1G2
3 Members
9 Guides authored
