Difficulty
Moderate
Steps
6
Time Required
Suggest a time??
Sections
1
- DeLonghi ESAM xxxx - Test Mode
- 6 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackDeLonghi ESAM family of coffee preparing automates
Full Screen
Options
History
Save to Favorites
Download PDF
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Step 1
Activate Test Mode
- Pull the plug. Switch on rear side is in position “On”.
- Press and hold both keys for “one cup” and “steam”.
- Reconnect the plug.
- LEDs light up. When they are off again, the machine is in test mode. Release the two keys.
- If there is no water in the reservoir or not all drawers are inserted correctly, corresponding LEDs will light up.
Pull the plug. Switch on rear side is in position “On”.
Press and hold both keys for “one cup” and “steam”.
Reconnect the plug.
LEDs light up. When they are off again, the machine is in test mode. Release the two keys.
If there is no water in the reservoir or not all drawers are inserted correctly, corresponding LEDs will light up.
1024
Step 2
Motor Test
- Press the key “one cup”. The motor should drive down. If it reaches the lower end position the correspondending LED will light up.
- Press the key two cups". The motor should drive upwards. If it reaches the upper end position the correspondending LED will light up.
- Tip: the brewing unit has to be in the right start position for correct function. It’s a good idea to take a foto or mark the position.
- If the lower four LEDs light up in sequence during later operation, the start position has not yet been set correctly. Take out the brewing unit and close the service door. Press the “one cup” and “two cups” buttons simultaneously, the motor will automatically search for the right position. Put the brewing unit back in.
Press the key “one cup”. The motor should drive down. If it reaches the lower end position the correspondending LED will light up.
Press the key two cups". The motor should drive upwards. If it reaches the upper end position the correspondending LED will light up.
Tip: the brewing unit has to be in the right start position for correct function. It’s a good idea to take a foto or mark the position.
If the lower four LEDs light up in sequence during later operation, the start position has not yet been set correctly. Take out the brewing unit and close the service door. Press the “one cup” and “two cups” buttons simultaneously, the motor will automatically search for the right position. Put the brewing unit back in.
Step 3
Pump Test
- Press the “steam” key. The pump should be activated. If the steam wand is opened the water should flow.
Press the “steam” key. The pump should be activated. If the steam wand is opened the water should flow.
Step 4
Grinder Test
- Press the “ECO” key. The grinder should be activated.
Press the “ECO” key. The grinder should be activated.
Step 5
Heater Test
- Press the “Rinse” key. One LED should light up and the heater should be activated. If it reaches the end temperature, the LED goes out.
Press the “Rinse” key. One LED should light up and the heater should be activated. If it reaches the end temperature, the LED goes out.
Step 6
- Pull the plug again to leave the test mode.
Pull the plug again to leave the test mode.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
VauWeh is helping us fix the world! Want to contribute? Start translating ›
Special thanks to these translators:
100%
VauWeh
Author
with 1 other contributor
VauWeh
Member since: 10/19/2015
160,518 Reputation
211 Guides authored
Badges:
41
+38 more badges