Difficulty
Very easy
Steps
3
Time Required
Suggest a time??
Sections
2
- DeLonghi ECAM back panel removal
- 2 steps
- DeLonghi ECAM Series left side panel
- 1 step
Flags
1
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackDeLonghi ECAM Series
Full Screen
Options
History
Save to Favorites
Download PDF
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
DeLonghi ECAM back panel removal
- Unplug the power cord!
- Remove all attachments such as water tank, pulp drawer, brew group.
- Turn the machine with the back facing you.
- Remove five Torx T20 security screws.
- A small hurdle: These screws have a pin in the middle, so the screwdriver must have a hole.
Unplug the power cord!
Remove all attachments such as water tank, pulp drawer, brew group.
Turn the machine with the back facing you.
Remove five Torx T20 security screws.
A small hurdle: These screws have a pin in the middle, so the screwdriver must have a hole.
1024
Step 2
- Lift out the back.
- The following components are immediately visible:
- grinder
- pump
- flowmeter
Lift out the back.
The following components are immediately visible:
grinder
pump
flowmeter
Step 3
DeLonghi ECAM Series left side panel
- Push the side panel back about 1.5 cm.
- Lift off the panel.
- The following compononents are exposed:
- Heater
- Expansion chamber
- Gear drive
- Steam valve
Push the side panel back about 1.5 cm.
Lift off the panel.
The following compononents are exposed:
Heater
Expansion chamber
Gear drive
Steam valve
To reassemble your device, follow the above steps in reverse order.
Cancel: I did not complete this guide.
VauWeh is helping us fix the world! Want to contribute? Start translating ›
Special thanks to these translators:
100%
VauWeh
Author
with 1 other contributor
VauWeh
Member since: 10/19/2015
160,518 Reputation
211 Guides authored
Badges:
41
+38 more badges