Dell Xps 18 Hdd Ssd Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          20 minutes

Sections

HDD/SSD
5 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

BackDell XPS 18
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              HDD/SSD

There are ten screws around the perimeter, circled in red in the second photo. Use a T8 Torx bit to remove these, and set them aside, we’ll need them when we’re done!
Place your XPS 18 face down on a flat surface. You may want to put a protective surface down such as a towel, microfiber cloth, etc., to make sure your screen doesn’t get scratched. I’m using blank newsprint paper which also works great to give us a nice light background for the photos!

There are ten screws around the perimeter, circled in red in the second photo. Use a T8 Torx bit to remove these, and set them aside, we’ll need them when we’re done!

Place your XPS 18 face down on a flat surface. You may want to put a protective surface down such as a towel, microfiber cloth, etc., to make sure your screen doesn’t get scratched. I’m using blank newsprint paper which also works great to give us a nice light background for the photos!

1024

Step 2

              Remove back panel

There are two feet/legs that fold out from the back. These are attached inside the unit, so fold them out before proceeding. You won’t be able to remove the back panel if they’re folded in.
There is a door on the right side that pushes in to allow access to the SD card port. This is a perfect place to insert your finger to get a good hold on the back panel. Use a finger to pull straight away from the unit to lift off the rear panel. It may stick a little but it will pull right off easily.

There are two feet/legs that fold out from the back. These are attached inside the unit, so fold them out before proceeding. You won’t be able to remove the back panel if they’re folded in.

There is a door on the right side that pushes in to allow access to the SD card port. This is a perfect place to insert your finger to get a good hold on the back panel. Use a finger to pull straight away from the unit to lift off the rear panel. It may stick a little but it will pull right off easily.

Step 3

              Unscrew the HDD caddy

The internals are revealed!
There is a narrow plastic strip that covers the haptic motor, some connectors, etc. Carefully peel it up and set it aside until you’re ready to close up the unit.

The internals are revealed!

There is a narrow plastic strip that covers the haptic motor, some connectors, etc. Carefully peel it up and set it aside until you’re ready to close up the unit.

Step 4

              Remove the HDD caddy

There are four Phillips screws here. Use the #0 phillips screwdriver to remove these.
Lift up the end of the drive opposite the connector slightly and pull the drive away from the connector. It will slide right out!

There are four Phillips screws here. Use the #0 phillips screwdriver to remove these.

Lift up the end of the drive opposite the connector slightly and pull the drive away from the connector. It will slide right out!

Step 5

              Remove the HDD from the caddy and install the SATA SSD

There are four phillips head screws, two on each side. Use the #0 driver to remove these and set them aside.
At this point if you’re installing a SATA SSD, slip it in the caddy, screw it in, and go backwards through the steps to button everything back up.

There are four phillips head screws, two on each side. Use the #0 driver to remove these and set them aside.

At this point if you’re installing a SATA SSD, slip it in the caddy, screw it in, and go backwards through the steps to button everything back up.

To reassemble your device, follow these instructions in reverse order. You’ll have to install an OS and possibly turn off SecureBoot in the EFI/BIOS setup utility.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 1 other contributor

                    Grey Hodge

Member since: 06/24/2010

526 Reputation

                                      3 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Member-Contributed Guide#

Introduction#

What you need#

#

#

#

#

#

#

#

Member-Contributed Guide

Introduction

What you need