Difficulty
Moderate
Steps
2
Time Required
2 minutes
Sections
1
- Bottom Cover
- 2 steps
Flags
0
BackDell XPS 15 9575
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Use caution when undoing the clips that hold the cover to the case so that the laptop is secure after reassembly.
What you need
Step 1
Bottom Cover
- For your safety, please make sure the device is powered off and the A/C adapter is unplugged.
- Use your T5 Torx driver to remove all eight 3.2mm hex screws holding down the back panel.
- Wedge an opening pick between the back cover and the base of the board, then slightly lift the tool to pop the clips on the back cover off.
For your safety, please make sure the device is powered off and the A/C adapter is unplugged.
Use your T5 Torx driver to remove all eight 3.2mm hex screws holding down the back panel.
Wedge an opening pick between the back cover and the base of the board, then slightly lift the tool to pop the clips on the back cover off.
1024
Step 2
- Make sure all screws are removed before you lift the panel to prevent any damage from occurring.
- Remove the bottom cover from the device when all sides are free.
Make sure all screws are removed before you lift the panel to prevent any damage from occurring.
Remove the bottom cover from the device when all sides are free.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Zack Homsey
Member since: 09/20/2019
103 Reputation
1 Guide authored
Badges:
5
+2 more badges
Team
Embry-Riddle Aeronautical University, Team S1-G1, Watkins Fall 2019
Member of Embry-Riddle Aeronautical University, Team S1-G1, Watkins Fall 2019
ERAU-WATKINS-F19S1G1
4 Members
8 Guides authored