Difficulty

Moderate

Steps

10

Time Required

                          25 - 50 minutes

Sections

3

  • Base Cover
  • 4 steps
  • Battery
  • 3 steps
  • Speaker
  • 3 steps

Flags

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackDell XPS 15 9570

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Before beginning the repair, be sure the device is powered off and unplugged from the charger.

What you need

Step 1

              Base Cover
  • Make sure your device is powered off and unplugged before starting
  • Flip the device over so the base cover of the computer is facing upwards.

Make sure your device is powered off and unplugged before starting

Flip the device over so the base cover of the computer is facing upwards.

1024

Step 2

  • Using a Torx T5 screwdriver, remove the ten 3 mm screws on the back.

Using a Torx T5 screwdriver, remove the ten 3 mm screws on the back.

Step 3

  • Flip open the system badge and with a Phillips #00, remove the two 8.5 mm screws.

Flip open the system badge and with a Phillips #00, remove the two 8.5 mm screws.

Step 4

  • Lift the back cover off of the device.

Lift the back cover off of the device.

Step 5

              Battery
  • Using the Phillips #00 screwdriver, remove the four 4 mm screws holding the battery in place.

Using the Phillips #00 screwdriver, remove the four 4 mm screws holding the battery in place.

Step 6

  • Use the iFixit opening tool to disconnect the battery connector from the motherboard.

Use the iFixit opening tool to disconnect the battery connector from the motherboard.

Step 7

  • With your hands, pick up and remove the battery from the system.

With your hands, pick up and remove the battery from the system.

Step 8

              Speaker
  • Using the iFixit opening tool, disconnect the speaker cable by pulling it out gently.

Using the iFixit opening tool, disconnect the speaker cable by pulling it out gently.

Step 9

  • Remove the four 2 mm screws using the Philips #00 screwdriver.
  • There are two on the left speaker and two on the right.
  • Follow the images for the right side to complete the left side as well.

Remove the four 2 mm screws using the Philips #00 screwdriver.

There are two on the left speaker and two on the right.

Follow the images for the right side to complete the left side as well.

Step 10

  • Remove the speakers from the back of the computer.

Remove the speakers from the back of the computer.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Margaret Combs

Member since: 09/08/2021

429 Reputation

                                      4 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       University of Alabama, Team 2-4, Bedsole Fall 2021                        

                                                  Member of University of Alabama, Team 2-4, Bedsole Fall 2021 



                    UA-BEDSOLE-F21S2G4                     


                                            3 Members                     


                                            11 Guides authored