Difficulty
Easy
Steps
5
Time Required
6 - 7 minutes
Sections
2
- Back/Underside Panel
- 3 steps
- RAM
- 2 steps
Flags
0
BackDell XPS 15 9550
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back/Underside Panel
- Turn the laptop upside down.
- Make sure the laptop is turned off.
- Use a T5 Torx Screwdriver to remove the ten 3 mm long screws from the perimeter of the back of the laptop.
Turn the laptop upside down.
Make sure the laptop is turned off.
Use a T5 Torx Screwdriver to remove the ten 3 mm long screws from the perimeter of the back of the laptop.
1024
Step 2
- Open up the information panel door (on the middle of the back side).
- While holding the door open, use a Phillips #00 Screwdriver to remove the two 10 mm long screws.
Open up the information panel door (on the middle of the back side).
While holding the door open, use a Phillips #00 Screwdriver to remove the two 10 mm long screws.
Step 3
- Carefully lift the 2 corners of the back panel close to the hinge upwards, to release the whole panel.
- Do not force the panel off. If it does not come off easily, try to use a plastic spudger where it is stuck.
Carefully lift the 2 corners of the back panel close to the hinge upwards, to release the whole panel.
Do not force the panel off. If it does not come off easily, try to use a plastic spudger where it is stuck.
Step 4
RAM
- There are 2 separate RAM sticks.
- Gently push down on the 2 outside tabs of the RAM stick you want to replace.
- While still pushing down, gently push the tabs outwards, causing the RAM stick to flip up.
There are 2 separate RAM sticks.
Gently push down on the 2 outside tabs of the RAM stick you want to replace.
While still pushing down, gently push the tabs outwards, causing the RAM stick to flip up.
Step 5
- Firmly grasp the RAM stick from the flipped up edge and gently pull out, to release the RAM stick.
Firmly grasp the RAM stick from the flipped up edge and gently pull out, to release the RAM stick.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
5 other people completed this guide.
Author
with 3 other contributors
jbaseballin2
Member since: 10/04/2018
117 Reputation
1 Guide authored
Badges:
5
+2 more badges
Team
UW Stout, Team S6-G1, Ogden Fall 2018
Member of UW Stout, Team S6-G1, Ogden Fall 2018
UWSTOUT-OGDEN-F18S6G1
4 Members
23 Guides authored
twrfan - Dec 28, 2018
Reply
What type ram do you replace it with? Could you post a link?