Difficulty

Moderate

Steps

12

Time Required

                          25 - 30 minutes

Sections

4

  • Base Cover
  • 3 steps
  • Battery
  • 3 steps
  • SSD
  • 3 steps
  • Screen
  • 3 steps

Flags

0

  • BackDell XPS 15 9530

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Base Cover
  • Using a T5 Torx screwdriver, remove ten 3mm screws.

Using a T5 Torx screwdriver, remove ten 3mm screws.

1024

Step 2

  • Lift the plastic tab.
  • Remove two 3mm Phillips #0 screws under the plastic tab.

Lift the plastic tab.

Remove two 3mm Phillips #0 screws under the plastic tab.

Step 3

  • Lift the lower case off.

Lift the lower case off.

Step 4

              Battery
  • Using a Phillips #0 screwdriver, remove the seven 3.5mm screws that secure the battery to the palm rest assembly.

Using a Phillips #0 screwdriver, remove the seven 3.5mm screws that secure the battery to the palm rest assembly.

Step 5

  • Disconnect the battery cable from the system board.
  • Be sure to use a plastic tool, not a metal one.

Disconnect the battery cable from the system board.

Be sure to use a plastic tool, not a metal one.

Step 6

  • Lift the battery off the chassis.

Lift the battery off the chassis.

Step 7

              SSD
  • Pull lift tabs and remove the plastic that covers the hard drive to expose the hard drive.

Pull lift tabs and remove the plastic that covers the hard drive to expose the hard drive.

Step 8

  • Using a Phillips #0 screwdriver, remove two 2.5mm screws that secure the SSD to the chassis.

Using a Phillips #0 screwdriver, remove two 2.5mm screws that secure the SSD to the chassis.

Step 9

  • Pull the SSD out parallel to the mainboard.

Pull the SSD out parallel to the mainboard.

Step 10

              Screen
  • Unplug the screen connector.

Unplug the screen connector.

Step 11

  • Using a Phillips #0 screwdriver, remove the four 4mm screws holding in the screen hinges.

Using a Phillips #0 screwdriver, remove the four 4mm screws holding in the screen hinges.

Step 12

  • Pull chassis away from screen assembly.

Pull chassis away from screen assembly.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors 


                    Larissa Omura

Member since: 04/04/2019

743 Reputation

                                      6 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Oregon Institute of Technology, Team S1-G3, Lancaster Spring 2019                        

                                                  Member of Oregon Institute of Technology, Team S1-G3, Lancaster Spring 2019 



                    OIT-LANCASTER-S19S1G3                     


                                            3 Members                     


                                            11 Guides authored