Dell Xps 15 9520 Back Cover Replacement Repair Guide

Difficulty

Moderate

Steps

5

Time Required

                          10 - 20 minutes            

Sections

1

• Back Cover
• 5 steps

Flags

0

• BackDell XPS 15 9520

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

The cover on this XPS is very sharp and is secured tightly to the laptop body. Work slowly to prevent cutting your hands.

What you need

Step 1

              Unfasten the back cover               

• For your safety, discharge the battery below 25% and power down your device before disassembly.
• Use a Torx T5 screwdriver to remove the eight 3.3 mm-long screws securing the back cover.

For your safety, discharge the battery below 25% and power down your device before disassembly.

Use a Torx T5 screwdriver to remove the eight 3.3 mm-long screws securing the back cover.

1024

Step 2

              Insert an opening pick               

• Insert an opening pick between the bottom-right corner of the aluminum back cover and the chassis.
• Leave the pick inserted before continuing to the next step.

Insert an opening pick between the bottom-right corner of the aluminum back cover and the chassis.

Leave the pick inserted before continuing to the next step.

Step 3

              Release the corner clip               

• Insert the flat end of the spudger into the gap you just created.
• Pry up to release the corner clips.
• Repeat this process for the opposite corner of the back cover.

Insert the flat end of the spudger into the gap you just created.

Pry up to release the corner clips.

Repeat this process for the opposite corner of the back cover.

Step 4

              Unclip the front edge               

• Reinsert your opening pick under the aluminum cover at the front edge of the laptop.
• Pry to loosen the cover.
• Pry at multiple locations along the front edge to release all of the retaining clips.
• Do not use a sliding motion along the front edge. This may damage cables near the trackpad.

Reinsert your opening pick under the aluminum cover at the front edge of the laptop.

Pry to loosen the cover.

Pry at multiple locations along the front edge to release all of the retaining clips.

Do not use a sliding motion along the front edge. This may damage cables near the trackpad.

Step 5

              Remove the back cover               

• The edges of the back cover are very sharp. Use caution when handling it.
• Lift the back cover off the chassis and remove it.
• If the back cover feels stuck to the chassis, use an opening pick to release any remaining clips around the back cover’s perimeter.

The edges of the back cover are very sharp. Use caution when handling it.

Lift the back cover off the chassis and remove it.

If the back cover feels stuck to the chassis, use an opening pick to release any remaining clips around the back cover’s perimeter.

To reassemble your device, follow these instructions in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Dell XPS answers community for help.

Cancel: I did not complete this guide.

Author

                    Clay Eickemeyer                     

Member since: 09/19/2022

14,946 Reputation

                                      125 Guides authored                  



                       Badges:
                       27







                                                        +24 more badges                           

Team

                       iFixit                        

                                                  Member of iFixit 



                    Community                     


                                            141 Members                     


                                            15,772 Guides authored