Difficulty
Moderate
Steps
5
Time Required
Suggest a time??
Sections
2
- Rear Panel
- 3 steps
- SSD
- 2 steps
Flags
3
Needs More Images
A few more images would make this guide’s procedures crystal clear.
Better Introduction
Improve this guide by completing or revising its introduction.
Missing Details
Some of this guide’s details are missing. Help users by adding tools, difficulty, or time.
BackDell XPS 15 9510
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Rear Panel
- Make sure the laptop is powered off and unplug all cables before beginning any repair.
- Remove eight 3 mm screws from the underside of the case using a T5 Torx screwdriver.
Make sure the laptop is powered off and unplug all cables before beginning any repair.
Remove eight 3 mm screws from the underside of the case using a T5 Torx screwdriver.
1024
Step 2
- The metal case of the XPS 15 9510 is extremely sharp, so be careful not to run your fingers along the edge when disassembling the laptop.
- Wedge the case apart with a nylon spudger.
- If the plastic one isn’t possible to insert, use the metal spudger to carefully create a small gap first.
- Once the spudger is inserted, slide it along each side of the laptop
The metal case of the XPS 15 9510 is extremely sharp, so be careful not to run your fingers along the edge when disassembling the laptop.
Wedge the case apart with a nylon spudger.
If the plastic one isn’t possible to insert, use the metal spudger to carefully create a small gap first.
Once the spudger is inserted, slide it along each side of the laptop
Step 3
- The metal case of the XPS 15 9510 is extremely sharp, so be careful not to run your fingers along the edge when disassembling the laptop.
- Lift the back panel of the laptop off and set it aside.
Lift the back panel of the laptop off and set it aside.
Step 4
SSD
- Remove the single screw from the left side of the SSD using a Phillips #00 screwdriver.
- The SSD is spring-released; it will pop up after removing the screw.
Remove the single screw from the left side of the SSD using a Phillips #00 screwdriver.
The SSD is spring-released; it will pop up after removing the screw.
Step 5
- Use your fingers to carefully remove the SSD from the laptop.
Use your fingers to carefully remove the SSD from the laptop.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Austin Sa
Member since: 03/30/2022
402 Reputation
3 Guides authored
Badges:
6
+3 more badges
Team
UMass Dartmouth, Team 1-3, Mellen Spring 2022
Member of UMass Dartmouth, Team 1-3, Mellen Spring 2022
UMASSD-MELLEN-S22S1G3
3 Members
5 Guides authored