Difficulty
Very difficult
Steps
3
Time Required
30 - 45 minutes
Sections
1
- LCD Screen Glass
- 3 steps
Flags
0
BackDell XPS 14Z L412Z
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
LCD Screen Glass
- Using the iFixit opening tools, carefully pry up the trim around the screen.
- It is recommended to start in a corner.
Using the iFixit opening tools, carefully pry up the trim around the screen.
It is recommended to start in a corner.
1024
Step 2
- Using a heat gun, carefully apply heat evenly across the glass.
Using a heat gun, carefully apply heat evenly across the glass.
Step 3
- Using the iFixit opening tools, carefully pry the glass off the screen.
- This is glass and will shatter if too much force is used.
Using the iFixit opening tools, carefully pry the glass off the screen.
This is glass and will shatter if too much force is used.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Colton Niewolny
Member since: 02/15/2018
411 Reputation
4 Guides authored
Badges:
8
+5 more badges
Team
UW Stout, Team S8-G3, Ogden Spring 2018
Member of UW Stout, Team S8-G3, Ogden Spring 2018
UWSTOUT-OGDEN-S18S8G3
4 Members
6 Guides authored
wiwi - Oct 24, 2018
Reply
to remove the black cover, use the rod of a pen pen cap. Spread both sides while pressing the top of the black cover (towards the inside of the screen). Must a little force.The closure mechanism is composed of two things that alternate every 2 cm: 1 clips that is sinking on the gray part (you have to lift the black part towards the right to take it out) then 1 rod that comes down in underneath (just stand aside - neither lift nor lower to remove)
