Dell Wyse Xn0M Mouse Sensor Board Replacement Repair Guide

Difficulty

Difficult

Steps

6

Time Required

                          20 minutes            

Sections

1

• Mouse Sensor Board
• 6 steps

Flags

0

• BackDell Wyse Xn0m

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

If your left-click or right-click buttons aren’t working, you may need to replace the board that controls those functions. Use this guide to learn how!

What you need

Step 1

              Mouse Sensor Board               

• Flip the device over. Unscrew nine marked 7mm Phillips #1 screws.

Flip the device over. Unscrew nine marked 7mm Phillips #1 screws.

1024

Step 2

• Remove the keyboard by pushing back the tabs at the marked locations with a spudger or plastic opening tool.

Remove the keyboard by pushing back the tabs at the marked locations with a spudger or plastic opening tool.

Step 3

• Turn the device around so the screen is closest to you. Lift the keyboard and detach the ribbon cable with the spudger.
• To disconnect the cable, disengage the locking tab of the ZIF connector with the spudger and pull the cable out gently.

Turn the device around so the screen is closest to you. Lift the keyboard and detach the ribbon cable with the spudger.

To disconnect the cable, disengage the locking tab of the ZIF connector with the spudger and pull the cable out gently.

Step 4

• Remove the keyboard and set it aside. Detach the other ribbon cables with the spudger.
• Remove five 8mm Phillips #1 screws.

Remove the keyboard and set it aside. Detach the other ribbon cables with the spudger.

Remove five 8mm Phillips #1 screws.

Step 5

• Pry open the laptop with the plastic opening tool.

Pry open the laptop with the plastic opening tool.

Step 6

• Under the trackpad, detach the ribbon cables with the spudger.
• Unscrew two 3mm Phillips #1 screws and lift the board from the pegs.
• Remove the board from the laptop.

Under the trackpad, detach the ribbon cables with the spudger.

Unscrew two 3mm Phillips #1 screws and lift the board from the pegs.

Remove the board from the laptop.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 2 other contributors 

                    Jake Milligan                     

Member since: 10/30/2019

296 Reputation

                                      1 Guide authored                  



                       Badges:
                       8







                                                        +5 more badges                           

Team

                       University of Memphis, Team S2-G1, Kim Fall 2019                        

                                                  Member of University of Memphis, Team S2-G1, Kim Fall 2019 



                    UM-KIM-F19S2G1                     


                                            4 Members                     


                                            3 Guides authored