Difficulty

Moderate

Steps

9

Time Required

                          25 minutes

Sections

2

  • Cover Panel
  • 4 steps
  • Screen
  • 5 steps

Flags

0

  • BackDell VRP100

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Cover Panel
  • Remove the black foam padding by peeling away slowly.
  • Remove the front and back padding from the headset by peeling away slowly.

Remove the black foam padding by peeling away slowly.

Remove the front and back padding from the headset by peeling away slowly.

1024

Step 2

  • Remove the six 5.5mm PH000 screws from the cover by rotating counter-clockwise.
  • Cover panel may need to be pushed in before inserting screws.

Remove the six 5.5mm PH000 screws from the cover by rotating counter-clockwise.

Cover panel may need to be pushed in before inserting screws.

Step 3

  • Remove the cover using one of the plastic opening tools, and then carefully pull it from the casing.

Remove the cover using one of the plastic opening tools, and then carefully pull it from the casing.

Step 4

  • Remove the six 5.5mm PH000 screws from the cover by rotating counter-clockwise.
  • Carefully remove the lens and motherboard assembly from the white casing.

Carefully remove the lens and motherboard assembly from the white casing.

Step 5

              Screen
  • Remove the four 2.5 mm PH000 screws by rotating counter-clockwise.
  • Separate the lenses from the motherboard panel.

Remove the four 2.5 mm PH000 screws by rotating counter-clockwise.

Separate the lenses from the motherboard panel.

Step 6

  • Take off the tape using the blunt nosed tweezers to disconnect the flat-topped connector from the motherboard.
  • The screen is attached to the motherboard using an adhesive.

Take off the tape using the blunt nosed tweezers to disconnect the flat-topped connector from the motherboard.

The screen is attached to the motherboard using an adhesive.

Step 7

  • Lift the yellow tape with tweezers.
  • Remove the ribbon cable from the screen to the motherboard with tweezers.

Lift the yellow tape with tweezers.

Remove the ribbon cable from the screen to the motherboard with tweezers.

Step 8

  • Remove the six 3.4mm PH000 screws by rotating counter-clockwise connecting the back panel to the screen.
  • Remove the back panel from the screen by carefully pulling apart the two.

Remove the six 3.4mm PH000 screws by rotating counter-clockwise connecting the back panel to the screen.

Remove the back panel from the screen by carefully pulling apart the two.

Step 9

  • Peel away the screen with both hands.
  • A plastic opening tool may be required for removing the screen.
  • Adhesive may need to be reapplied during the rebuild.

Peel away the screen with both hands.

A plastic opening tool may be required for removing the screen.

Adhesive may need to be reapplied during the rebuild.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Lauren Monzon

Member since: 10/08/2018

217 Reputation

                                      2 Guides authored                  



                       Badges:
                       3

Team

                       Cal Poly, Team S17-G1, White Fall 2018                        

                                                  Member of Cal Poly, Team S17-G1, White Fall 2018 



                    CPSU-WHITE-F18S17G1                     


                                            4 Members                     


                                            12 Guides authored