Difficulty

Moderate

Steps

7

Time Required

                          25 minutes

Sections

2

  • Cover Panel
  • 4 steps
  • Lens
  • 3 steps

Flags

1

This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.

  • BackDell VRP100

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Cover Panel
  • Remove the black foam padding by peeling away slowly.
  • Remove the front and back padding from the headset by peeling away slowly.

Remove the black foam padding by peeling away slowly.

Remove the front and back padding from the headset by peeling away slowly.

1024

Step 2

  • Remove the six 5.5mm PH000 screws from the cover by rotating counter-clockwise.
  • Cover panel may need to be pushed in before inserting screws.

Remove the six 5.5mm PH000 screws from the cover by rotating counter-clockwise.

Cover panel may need to be pushed in before inserting screws.

Step 3

  • Remove the cover using one of the plastic opening tools, and then carefully pull it from the casing.

Remove the cover using one of the plastic opening tools, and then carefully pull it from the casing.

Step 4

  • Remove the six 5.5mm PH000 screws from the cover by rotating counter-clockwise.
  • Carefully remove the lens and motherboard assembly from the white casing.

Carefully remove the lens and motherboard assembly from the white casing.

Step 5

              Lens
  • Deattach the black cover from the lens with a metal spudger.
  • This will “click” back into place during replacement.

Deattach the black cover from the lens with a metal spudger.

This will “click” back into place during replacement.

Step 6

  • Gently insert the metal spudger between the lens and the lens casing.
  • Rotate the spudger around the exterior of the lens and lens housing, separating them.
  • The lens is held in place with an adhesive that will have to be applied during reassembly.

Gently insert the metal spudger between the lens and the lens casing.

Rotate the spudger around the exterior of the lens and lens housing, separating them.

The lens is held in place with an adhesive that will have to be applied during reassembly.

Step 7

  • Holding the lens around the outside, gently lift it out of its housing.

Holding the lens around the outside, gently lift it out of its housing.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors 


                    Chris Grabow

Member since: 10/08/2018

285 Reputation

                                      2 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Cal Poly, Team S17-G1, White Fall 2018                        

                                                  Member of Cal Poly, Team S17-G1, White Fall 2018 



                    CPSU-WHITE-F18S17G1                     


                                            4 Members                     


                                            12 Guides authored