Difficulty

Moderate

Steps

7

Time Required

                          20 minutes

Sections

2

  • Cover Panel
  • 4 steps
  • Camera
  • 3 steps

Flags

0

  • BackDell VRP100

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Cover Panel
  • Remove the black foam padding by peeling away slowly.
  • Remove the front and back padding from the headset by peeling away slowly.

Remove the black foam padding by peeling away slowly.

Remove the front and back padding from the headset by peeling away slowly.

1024

Step 2

  • Remove the six 5.5mm PH000 screws from the cover by rotating counter-clockwise.
  • Cover panel may need to be pushed in before inserting screws.

Remove the six 5.5mm PH000 screws from the cover by rotating counter-clockwise.

Cover panel may need to be pushed in before inserting screws.

Step 3

  • Remove the cover using one of the plastic opening tools, and then carefully pull it from the casing.

Remove the cover using one of the plastic opening tools, and then carefully pull it from the casing.

Step 4

  • Remove the six 5.5mm PH000 screws from the cover by rotating counter-clockwise.
  • Carefully remove the lens and motherboard assembly from the white casing.

Carefully remove the lens and motherboard assembly from the white casing.

Step 5

              Camera
  • Remove the four 2.5mm PH000 screws by rotating counter-clockwise.
  • Separate the lens housing from the motherboard panel.

Remove the four 2.5mm PH000 screws by rotating counter-clockwise.

Separate the lens housing from the motherboard panel.

Step 6

  • Remove the two 2.5mm PH000 screws from the motherboard by rotating counter-clockwise.
  • Remove the four 3.9mm PH000 screws from the white casing by rotating counter-clockwise.

Remove the two 2.5mm PH000 screws from the motherboard by rotating counter-clockwise.

Remove the four 3.9mm PH000 screws from the white casing by rotating counter-clockwise.

Step 7

  • Remove the flat-topped connector by lifting it straight up from the motherboard.
  • Carefully remove the camera from the casing with the blunt nose tweezers by holding onto the copper tape.
  • To reinstall, line up the connectors and firmly push until you hear a pop.

Remove the flat-topped connector by lifting it straight up from the motherboard.

Carefully remove the camera from the casing with the blunt nose tweezers by holding onto the copper tape.

To reinstall, line up the connectors and firmly push until you hear a pop.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Lauren Monzon

Member since: 10/08/2018

217 Reputation

                                      2 Guides authored                  



                       Badges:
                       3

Team

                       Cal Poly, Team S17-G1, White Fall 2018                        

                                                  Member of Cal Poly, Team S17-G1, White Fall 2018 



                    CPSU-WHITE-F18S17G1                     


                                            4 Members                     


                                            12 Guides authored