Dell Venue 8 Speaker Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          5 - 10 minutes

Sections

Rear Case/Midframe
2 steps
Speaker
2 steps

Flags

BackDell Venue 8
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Rear Case/Midframe

Hold the device with the screen facing up. Gently wedge your plastic opening tool into the crease, and run it along the perimeter of the case
You will hear click sounds as the clips unhinge
Remove the back panel of the device.

Hold the device with the screen facing up. Gently wedge your plastic opening tool into the crease, and run it along the perimeter of the case

You will hear click sounds as the clips unhinge

Remove the back panel of the device.

1024

Step 2

Remove the 14 screws with the T-5 Torx screwdriver. (11 black 3.6mm screws, and three 4.45mm screws)
The silver screws are marked with an “S” or a sticker [S1.6(Silver)] See the corrected image
4.45mm Silver screws
3.6mm Black screws
Gently snap the perimeter clips open, and remove the internal plastic case.

Remove the 14 screws with the T-5 Torx screwdriver. (11 black 3.6mm screws, and three 4.45mm screws)

The silver screws are marked with an “S” or a sticker [S1.6(Silver)] See the corrected image

4.45mm Silver screws

3.6mm Black screws

Gently snap the perimeter clips open, and remove the internal plastic case.

Step 3

              Speaker

Using your plastic opening tool, unclip the speaker connection from the logic board.
Caution: Pull directly up, not out, on the connection

Using your plastic opening tool, unclip the speaker connection from the logic board.

Caution: Pull directly up, not out, on the connection

Step 4

Remove the speaker by placing using your plastic opening tool in the gap on the top of the speaker and prying it up.
The speaker is held on by light adhesive

Remove the speaker by placing using your plastic opening tool in the gap on the top of the speaker and prying it up.

The speaker is held on by light adhesive

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Andrea

Member since: 02/19/2015

1,056 Reputation

                                      5 Guides authored                  



                       Badges:
                       19







                                                        +16 more badges

Team

                       USF Tampa, Team 9-2, Leahy Winter 2015                        

                                                  Member of USF Tampa, Team 9-2, Leahy Winter 2015 



                    USFT-LEAHY-W15S9G2                     


                                            3 Members                     


                                            12 Guides authored

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team