Dell Streak 10 Pro Sd Card Breakout Board Replacement Repair Guide

Difficulty

Moderate

Steps

8

Time Required

Suggest a time??

Sections

2

• Battery
• 4 steps
• SD Card Breakout Board
• 4 steps

Flags

0

• BackDell Streak 10 Pro

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Battery               

• Place the device flat on its screen.
• Using the plastic opening tools, pry open the top segment of the tablet where the camera is located.
• Take the segment off and place it to the side.

Place the device flat on its screen.

Using the plastic opening tools, pry open the top segment of the tablet where the camera is located.

Take the segment off and place it to the side.

1024

Step 2

• Remove four 4mm Phillips #0 screws.

Remove four 4mm Phillips #0 screws.

Step 3

• Using the plastic opening tool, lift off the entire back screen of the tablet.

Using the plastic opening tool, lift off the entire back screen of the tablet.

Step 4

• Disconnect the no-fuss ribbon cable connector.
• The best way is to safely pull the white connector straight out of the socket. Using the tweezers, pull out the white connector that contains the red, green, blue, and black cords connected to it.
• Remove the battery by gently lifting it out of the device.

Disconnect the no-fuss ribbon cable connector.

The best way is to safely pull the white connector straight out of the socket. Using the tweezers, pull out the white connector that contains the red, green, blue, and black cords connected to it.

Remove the battery by gently lifting it out of the device.

Step 5

              SD Card Breakout Board               

• Remove three 4mm Phillips #0 screws.

Remove three 4mm Phillips #0 screws.

Step 6

• Gently lift up the black covered wire and place it on the side, so that it is not in the way of the procedure.

Gently lift up the black covered wire and place it on the side, so that it is not in the way of the procedure.

Step 7

• When encountering a zero insertion force connector, the best way it to carefully use tweezers to flip up the white locking flap securing the blue-tipped ribbon cable.
• Then, gently use the tweezers to pull out the blue-tipped ribbon cable from the unlatched connector.

When encountering a zero insertion force connector, the best way it to carefully use tweezers to flip up the white locking flap securing the blue-tipped ribbon cable.

Then, gently use the tweezers to pull out the blue-tipped ribbon cable from the unlatched connector.

Step 8

• Use two fingers and gently pull the SD card breakout board from its space.

Use two fingers and gently pull the SD card breakout board from its space.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    Kayji Arai                     

Member since: 02/05/2019

211 Reputation

                                      2 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge                           

Team

                       UC Davis, Team S20-G7, Lore Winter 2019                        

                                                  Member of UC Davis, Team S20-G7, Lore Winter 2019 



                    UCD-LORE-W19S20G7                     


                                            2 Members                     


                                            4 Guides authored