Dell Streak 10 Pro Rear Camera Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 minutes

Sections

Battery
4 steps
Rear Camera
3 steps

Flags

BackDell Streak 10 Pro
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery

Place the device flat on its screen.
Using the plastic opening tools, pry open the top segment of the tablet where the camera is located.
Take the segment off and place it to the side.

Place the device flat on its screen.

Using the plastic opening tools, pry open the top segment of the tablet where the camera is located.

Take the segment off and place it to the side.

1024

Step 2

Remove four 4mm Phillips #0 screws.

Remove four 4mm Phillips #0 screws.

Step 3

Using the plastic opening tool, lift off the entire back screen of the tablet.

Using the plastic opening tool, lift off the entire back screen of the tablet.

Step 4

Disconnect the no-fuss ribbon cable connector.
The best way is to safely pull the white connector straight out of the socket. Using the tweezers, pull out the white connector that contains the red, green, blue, and black cords connected to it.
Remove the battery by gently lifting it out of the device.

Disconnect the no-fuss ribbon cable connector.

The best way is to safely pull the white connector straight out of the socket. Using the tweezers, pull out the white connector that contains the red, green, blue, and black cords connected to it.

Remove the battery by gently lifting it out of the device.

Step 5

              Rear Camera

Disconnect the no-fuss ribbon cable connector. Using tweezers, carefully pull the connector straight out of the socket.
The white connector is attached to a black wire.

Disconnect the no-fuss ribbon cable connector. Using tweezers, carefully pull the connector straight out of the socket.

The white connector is attached to a black wire.

Step 6

Disconnect the delicate ribbon cable from the Zero Insertion Force (ZIF) Connector.
To disconnect the cable, use the tip of a spudger or your fingernail to flip up the small black locking flap. Then, you can safely pull the cable out.

Disconnect the delicate ribbon cable from the Zero Insertion Force (ZIF) Connector.

To disconnect the cable, use the tip of a spudger or your fingernail to flip up the small black locking flap. Then, you can safely pull the cable out.

Step 7

Using the tweezer, carefully wiggle off the camera attached to the base.
This may take a few minutes. Be gentle while applying pressure.
After it wiggles free, lift the camera away from the base of the tablet.

Using the tweezer, carefully wiggle off the camera attached to the base.

This may take a few minutes. Be gentle while applying pressure.

After it wiggles free, lift the camera away from the base of the tablet.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Kayji Arai

Member since: 02/05/2019

211 Reputation

                                      2 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       UC Davis, Team S20-G7, Lore Winter 2019                        

                                                  Member of UC Davis, Team S20-G7, Lore Winter 2019 



                    UCD-LORE-W19S20G7                     


                                            2 Members                     


                                            4 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team