Difficulty
Moderate
Steps
4
Time Required
20 minutes
Sections
1
- Battery
- 4 steps
Flags
0
BackDell Streak 10 Pro
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Place the device flat on its screen.
- Using the plastic opening tools, pry open the top segment of the tablet where the camera is located.
- Take the segment off and place it to the side.
Place the device flat on its screen.
Using the plastic opening tools, pry open the top segment of the tablet where the camera is located.
Take the segment off and place it to the side.
1024
Step 2
- Remove four 4mm Phillips #0 screws.
Remove four 4mm Phillips #0 screws.
Step 3
- Using the plastic opening tool, lift off the entire back screen of the tablet.
Using the plastic opening tool, lift off the entire back screen of the tablet.
Step 4
- Disconnect the no-fuss ribbon cable connector.
- The best way is to safely pull the white connector straight out of the socket. Using the tweezers, pull out the white connector that contains the red, green, blue, and black cords connected to it.
- Remove the battery by gently lifting it out of the device.
Disconnect the no-fuss ribbon cable connector.
The best way is to safely pull the white connector straight out of the socket. Using the tweezers, pull out the white connector that contains the red, green, blue, and black cords connected to it.
Remove the battery by gently lifting it out of the device.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Matthew Ko
Member since: 02/05/2019
440 Reputation
2 Guides authored
Badges:
6
+3 more badges
Team
UC Davis, Team S20-G7, Lore Winter 2019
Member of UC Davis, Team S20-G7, Lore Winter 2019
UCD-LORE-W19S20G7
2 Members
4 Guides authored