Difficulty

Easy

Steps

5

Time Required

                          5 - 10 minutes

Sections

2

  • Case
  • 4 steps
  • Memory Board
  • 1 step

Flags

0

  • BackDell OptiPlex FX170

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Case
  • With the base stand facing upwards, unscrew the 6mm Phillips #2 screw.
  • Pull the base stand straight up from the device.

With the base stand facing upwards, unscrew the 6mm Phillips #2 screw.

Pull the base stand straight up from the device.

1024

Step 2

  • Unscrew and remove the eight 4mm Phillips #0 screws (four on top, four on bottom) from the top and bottom of the device.

Unscrew and remove the eight 4mm Phillips #0 screws (four on top, four on bottom) from the top and bottom of the device.

Step 3

  • Run the flat side of the spudger along the entire line of the case starting from the back where the power plug and a small screw are located.
  • Use care to not apply excessive force that could damage retaining clips while running the spudger along the case.

Run the flat side of the spudger along the entire line of the case starting from the back where the power plug and a small screw are located.

Use care to not apply excessive force that could damage retaining clips while running the spudger along the case.

Step 4

  • Once the clips have been released, gently disengage the cover from the rest of case by pulling in opposite directions.

Once the clips have been released, gently disengage the cover from the rest of case by pulling in opposite directions.

Step 5

              Memory Board
  • Using the spudger, gently push on the underside of the memory board to loosen it. Gently grasp each side and pull up to release the memory board.

Using the spudger, gently push on the underside of the memory board to loosen it. Gently grasp each side and pull up to release the memory board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Ashley Hansen

Member since: 01/13/2015

237 Reputation

                                      2 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Eastern Washington University, Team 1-4, Carnegie Winter 2015                        

                                                  Member of Eastern Washington University, Team 1-4, Carnegie Winter 2015 



                    EWU-CARNEGIE-W15S1G4                     


                                            3 Members                     


                                            13 Guides authored