Dell Latitude St Screen Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          20 minutes

Sections

Battery
6 steps
Screen
3 steps

Flags

BackDell Latitude ST
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery

Locate the back panel tab.
Press down on the tab to remove the panel.

Locate the back panel tab.

Press down on the tab to remove the panel.

1024

Step 2

Using a Phillips #0 screwdriver, remove the four 6mm screws attaching the inside panel to the device.

Using a Phillips #0 screwdriver, remove the four 6mm screws attaching the inside panel to the device.

Step 3

Use the blue plastic opening tool to push in the tab located on the backside of the device.
Slide the tool around the edges of the device to unsnap the tabs and pry the frame off.

Use the blue plastic opening tool to push in the tab located on the backside of the device.

Slide the tool around the edges of the device to unsnap the tabs and pry the frame off.

Step 4

Remove the three 6mm Phillips #0 screws attaching the battery.

Remove the three 6mm Phillips #0 screws attaching the battery.

Step 5

Using your hands or a plastic opening tool, unplug the white battery cable.
Push forward on the top part of the cable to disconnect it from the device.

Using your hands or a plastic opening tool, unplug the white battery cable.

Push forward on the top part of the cable to disconnect it from the device.

Step 6

Pull up on the black tab located at the top of the battery to remove the battery from the device.

Pull up on the black tab located at the top of the battery to remove the battery from the device.

Step 7

              Screen

Pull up on the copper antenna tape to loosen it from the base.
Unscrew the seven 6mm Phillips #0 screws from the base.

Pull up on the copper antenna tape to loosen it from the base.

Unscrew the seven 6mm Phillips #0 screws from the base.

Step 8

Locate the grey LCD cable attached to the motherboad on the device.
Pull up on the black tape handle attached to the LCD cable to disconnect the cable.
Be sure to pull on the back rather than the LCD cable itself.

Locate the grey LCD cable attached to the motherboad on the device.

Pull up on the black tape handle attached to the LCD cable to disconnect the cable.

Be sure to pull on the back rather than the LCD cable itself.

Step 9

Using your hands or the blue plastic opening tool, go along the edges of the frame and unsnap the screen from the middle frame.
Lift the middle frame away from the screen.

Using your hands or the blue plastic opening tool, go along the edges of the frame and unsnap the screen from the middle frame.

Lift the middle frame away from the screen.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Addie Kenney

Member since: 04/11/2017

413 Reputation

                                      4 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Eastern Washington University, Team S1-G1, Crane Spring 2017                        

                                                  Member of Eastern Washington University, Team S1-G1, Crane Spring 2017 



                    EWU-CRANE-S17S1G1                     


                                            3 Members                     


                                            5 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team