Difficulty

Moderate

Steps

6

Time Required

                          5 minutes

Sections

1

  • Heat Sink
  • 6 steps

Flags

0

  • BackDell Latitude E6510

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Heat Sink
  • Locate the tabs that lock the battery in place.
  • Push tabs towards each other while simultaneously pushing the battery away from the device.

Locate the tabs that lock the battery in place.

Push tabs towards each other while simultaneously pushing the battery away from the device.

1024

Step 2

  • Unscrew the screw located in the center of the back panel. Do not completely remove the screw, a spring will keep it in place when it has been loosened.
  • Slide the panel back until it unlocks.

Unscrew the screw located in the center of the back panel. Do not completely remove the screw, a spring will keep it in place when it has been loosened.

Slide the panel back until it unlocks.

Step 3

  • Locate the fan plug.
  • Pull up until it is unplugged from the reciever.
  • Take caution when unplugging the fan plug from the receiver.

Locate the fan plug.

Pull up until it is unplugged from the reciever.

Take caution when unplugging the fan plug from the receiver.

Step 4

  • Unscrew the two 5.5 mm screws securing the fan.
  • Lift the end of the fan opposite the copper wire up.
  • Pull the fan away from the device.

Unscrew the two 5.5 mm screws securing the fan.

Lift the end of the fan opposite the copper wire up.

Pull the fan away from the device.

Step 5

  • Locate and loosen the four silver screws holding down the heat redistribute component.
  • Do not competely remove the screws as springs keep the screws attached to the metal plate after you loosen them.

Locate and loosen the four silver screws holding down the heat redistribute component.

Do not competely remove the screws as springs keep the screws attached to the metal plate after you loosen them.

Step 6

  • Lift the metal plate up on the end closest to the screws.
  • Slide the whole assembly away from where you removed the fan.

Lift the metal plate up on the end closest to the screws.

Slide the whole assembly away from where you removed the fan.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 2 other contributors 


                    Noah

Member since: 02/05/2019

327 Reputation

                                      2 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       The Citadel Military College of South Carolina, Team S2-G2, Eggleston Spring 2019                        

                                                  Member of The Citadel Military College of South Carolina, Team S2-G2, Eggleston Spring 2019 



                    CMCSC-EGGLESTON-S19S2G2                     


                                            2 Members                     


                                            2 Guides authored